Hi, I hve JVC TH G30 and i have connected my DishTV receiver (not HD) to the Aux port of the device. I can get sounds only on the front left and right speakers.. Is there an option to get surround for this kind of inputs.. for the rest surround is working perfect..

Need help guys. Jvc thg30 turns on then after several seconds displays goodbye and turns off

Get the manual and familiarize with the setup and troubleshooting instructions.

http://www.retrevo.com/support/JVC-TH-G30-Home-Theater-Systems-manual/id/20067bh042/t/2/

Hi,

• If I understand your question correctly you want to listen your TV on your Stereo system thru your receiver,JVC TH-M606 ** you need to connect "Audio Output " RCA jacks or "Optic cable output" of your TV
  

** to "AUX input " or "TV" OR "Any input" of your receiver ( except Phone ) or "Optic Cable input"
** than just switch to respective mode on JVC TH-M606 RECEIVER corresponding your RCA or Optic connection...
There you go..Your TV sound is on the JVC TH-M606 Receiver..By this means whatever you watch on the TV (tuner, satellite , Xbox ) ,it's sound will come thru your stereo..

• If you want to listen your receiver thru your TV, sorry but it is not a preferable attempt since TV sound system is not a HI-FI quality compare to your nice Receiver..if you really want to do it,try to do the connections given above in reverse..
  

• And,best of my knowledge I am afraid you can not put in progressive mode without remote
• 
  
• Hope this helps!

Take care and please Remember to rate/vote and give me 4 Thumbs Up for me to continue for Helping out the Community :)

http://books.jvc.com/booklist.asp?Model=TH-G30

When viewing on Digital TV:-
Sometimes Audio and Video signal can not be transmitted simultaneously due to additional process time for the video signal compared to that of the audio signal.
Often video signal takes more time than the audio signal to convert from analogue signal to digital signal in the Digital TV.
It may result in mismatch of the picture and sound.
In the TH-G30/40's HD AV Sync menu, you can adjust the audio signal delay for simultaneous AV signal transmission
1. Delay time can be varied in 10msec steps.(0 to 300ms)
2. Delay time is different between TV Brands.
So you need to adjust the delay time for correct lip-sync.
The adjustment is listed in the instruction book page12

Apparently, the use of the built-in DVD player doesn't allow sound field manipulation; but external sources can be modified. This subject is only discussed in this section of the manual...

"Enjoying audio form an external
source
You can enjoy audio form an external source through
your unit.
Press INPUT repeatedly to select the desired input
source. - AUX, AUX OPT, AUDIO IN
Setting the surround mode
You can select the Dolby Pro Logic II. Press
SURROUND to change surround mode repeatly...."

jvc g30 reads locked now whenever i try to open it to play a dvd

Well I am assuming that you have a HD tv, If so than you can run HDMI from Ps3 to Tv then run optical audio wire from ps3 to reciever.To listen to ps3 turn reciever to aux setting.

Hope this helps

You can try a code seach which many universal remotes will do, this may be called auto search, if you have the manual for the RCA see if it is listed, instead of entering a 3 digit code, you cycle through all codes until the correct one responds to the unit you are trying to program.

Check the cables from the DVD to the Amp and make certain your in Dolby Digital mode on player.