Connect some text-based terminal emulator such as Hyperterm, telnet,VT100, etc to the serial port. Configure the emilator
to19200 Baud 8 plus none.
Switch the 4924 on and login using the user "recover" (without quotes) and password "recover" (also without quotes.
The switch will go into recovery mode. It will display a count-down starting at 30 seconds. If you power thye switch off before the count is up, the default password for the main administration account "admin" will be cleared.
After a few seconds, power the switch on and set a new admin password.
After loigging in again, take the option "GettingStarted". Configure the ip settings (best to use a static address) and eventually you will get to the "Initialize" option. Enter yes, and after reboot it will be at factory except for its ip address.
357 views
Usually answered in minutes!
×