Need a manual for a Raytheon Fish Finder Model 1365. Bought a used boat with a unit but no literature. Can you help?

Most boats do not come with a manual for the boat itself. Each system on the boat has it's own manual/instructions. There should be one for the motor, one for trolling motor, one for depth/fish finder, one for stereo, etc. These manuals are usually available online or from the manufacturer. Likewise for other components such as bilge pumps, trim/tilt units, etc. The boat itself is just a piece of fiberglass with systems and components installed on it. You won't find a standalone owners manual for your rig with everything in it. They don't exist.

Hey Anon
The transducer installation is more important than anything.. next to correct wiring! You must make sure the mounting is good,,, if its outside the hull, make sure its sitting 1/16th below the hull with no obstructions.. if its inside the hull, the medium you used to fix the puck to the hull must be porosity free and the puck sitting as level with the WATER as possible..
Now, take the manual to the lake with you and DO NOTHING but read the manual and apply what you read to the unit,,, read -repeat - read-repeat.. forget about fishing... now read-repeat and learn... IF nothing seems to be reading correctly.. its probably the transducer installation.. YOU DID use a/the transducer specifically for this unit!!

Had a problem with my Humminbird. Took connectors out of cradle and ran direct into unit to check cradle, no difference.
Check your getting 12 volts of power to cradle. Did all this and ended up taking finder into a shop and plugging into their set up demo model and still nothing. Unit is stuffed, I'll replace it with similar brand to utilize cradle, wiring and sending unit

Hi!

No problem. Here's the link to your manual!

http://www.manualnguide.com/dl/15864/

Happy Boating!

I NEED A TRANSDUCER FOR AN EAGLE-168.
SOMEONE CONTACT ME. PLEASE..............

[email protected]

i have an older fishin buddy 2 bottom line sidefinder i need a manual, a bracket that holds it to the boat and the battery holder / handle i hope you can help me with this my email [email protected]

hi guys i need the manual guide for cvs-106mk2 in greek version....

http://www.humminbird.com/PDF/lcr4000.pdf

I hope this is the one you are looking for.

There is not a Uniden Marine Electronic with MC-600. Here's are all the manuals for Uniden Marine Electronics =>

http://www.uniden.com/index/manuals_results.cfm?cat=7

If it's the Cobra Fish Finder MC600, here's the operation manual =>

http://www.cobra.com/downloads/manuals/MC600C_MANL_ENG1.pdf

I don't think your old fish finder is the LMS-332C GPS Receiver listed above in the description. You don't need the speed wheel for the fish finder to function just the transducer and transducer mount. You should mount that on the back of the boat towards the center but not too close to the motor and not too close to the side of the board. Don't let it hand below the level of the boat. That should keep it from getting hit by the trailer or dragging on the bottom. Try to make it as level as possible. The green and white wires may be for the speed wheel but i'd need a model number for clarification. Hope this helps.