How do the wheels install - Shop Vac 925-13 Canister Wet/Dry Vacuum

If your Roomba 980 is still displaying an error 10 (left wheel error) after installing a new module wheel, it could be due to a problem with the new module wheel or with another part of the vacuum. Here are a few things you can try to troubleshoot the problem:

1. Make sure that the new module wheel is properly installed and seated in the vacuum.
2. Check the connections between the module wheel and the vacuum's main board to make sure they are secure and not loose.
3. Check the left wheel and the left wheel motor to make sure they are not damaged or malfunctioning.
4. If the problem persists after trying these troubleshooting steps, you may need to take the vacuum to a repair center for further diagnosis and repair.

I hope this information is helpful! Let me know if you have any other questions.

The gears on the rear wheel assembly have to be aligned properly before they can be fastened in place, otherwise the rear axel will be crooked and and will not sit level. Your post is from 5 months ago, have you resolved the issue yet?

This spring can be very confusing to install. It slides onto the wheel assembly near where the attaching pin is longer ( there are flat protrusions on both sides of the wheel assembly). One end of the spring pushes up on the assembly when it is in place, and the free end must be pulled down and inserted into the small slot in the bottom of the base. Pull down on the shorter end of the spring, holding the longer end, and slide it onto the round area on the wheel assembly. As you put the wheels back on, pull on the longer end and insert it into the slot in the base.

install the belt on the motor shaft first by sliding it sideways between the shaft and housing. then install on the brushroll and stretch in place

You should be able to purchase one from any Hoover dealer. Cost of this part is about $5 USD. The wheels and axles do not come with it, but need to be installed into the new one. Hoover.com you can lookup your nearest dealer.

I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_b96ba3f038cf317c

on this machine the spring goes to the front wheel assembly under the machine. if this has came off then the wheel assembly is broken. i believe the part # is 36432027. hope this helps

Try equalizing the space between the two wheels and the drive shaft. If it's not equal, they may not fit properly, or at all.

on the wheel assembly you will see on each end the studs with the flat ends on them,slide the studs in the slots and fold wheels forward and push in.in the middle at the front of the wheels you will see a flat catch ,push it up into the base right behind the brush roller and it will snap in

You must take the top off to put the part installed it will not go in from the bottom.

There is a spot that sticks up on the holder for the wheels, the hole in the spring goes there, then it fits between the holder and the base asm.