Need instructions no instructions for the disney princess bed tent canopy passed on from relative

Can someone get me the copy of the instructions for the metal Disney princess carriage bed

Possibly similar or same bed but not Disney:

https://www.dhpfurniture.com/eng/DHPFiles/ProductDocuments/B34325909800_Metal%20Twin%20Carriage%20Bed_White_APPROVED_2013.09.27.pdf

there is no manual,look at the picture and copy it

Here are a few sites to get you started with your search; however I strongly advise you to shop around and compare pricing.

http://www.princesscanopybeds.com/http-//www-princesscanopybeds-com/canopy-beds/cat-5-html/cat_5.html

http://www.ebay.com/sch/i.html?_nkw=princess+bed+canopy

http://www.walmart.com/ip/Canopy-Wrought-Iron-Princess-Bed-Pink/17127990

You can either get the complete tent bed from walmart, butif you want variety of colors and shapes, you can simply get a tent and put iton the bed, just make sure to check the tent and bed s before you buy sothey'll fit to eachother.This is the walmart site: http://www.walmart.com/ip/Disney-Toddler-Bed-with-Canopy-or-Tent-Your-Choice-of-Character/15522814

Here is a picture I finally found on ebay It was so frustrating trying to find these so I wanted to share with you

i have in pdf , email [email protected]

1

Remove the tent and poles from the packaging. Select an indoor area with a high ceiling or an outdoor area without overhead obstacles. The poles are not excessively long but they will be difficult to assemble without space.

2

Lay the Princess tent with the floor on the ground. Pull on each corner to tighten the floor. Assemble the two tent poles by inserting the male sections into the metal ferrules.

3

Slide one pole through each of the diagonal sleeves. Place the end of each pole in the fabric pockets on the corners. This will flex the poles and raise the tent body.

4

Place the fabric roof on top of the tent. Attach the hooks on each corner of the roof to the loops on the top of the pole sleeves. The roof fabric will stretch tight and cover the ventilation gap in the tent ceiling.

Use the hardware that comes with the Disney Princess canopy package to install the main canopy hook in your ceiling. Center the steel ceiling hook above the center of the twin bed and screw it into the ceiling by hand or with pliers. 2 Follow the included instructions and insert the four poles into the sleeves of the canopy. The two longer poles will run lengthwise above the bed, while the two shorter pieces will run widthwise above the bed. 3 Attach the canopy to the ceiling hook by slipping the plastic ring of the canopy onto the hook. The four polyester sides of the canopy should now hang over the twin bed. 4 Use the customer support form through the Exxel Outdoors website if you have questions regarding your Disney Princess canopy.

I just put one of these up today with no instructions so I am going to share my experience. In my Disney bed tent there were two long sets of poles held together by an elastic string. 1) put these two sets of poles together. Now you should have two long poles. 2) Turn the three way brackets all the same direction on both long poles. 3) Lay out the tent and look in each corner of the tent for a little pocket to insert the end of a long pole...taking the other end insert into pocket, not diagonally, straight across the long way. 4) Do the same with the other side of the tent and long pole. 5) Now take your ten short poles and attach two together making 5 medium sized poles 6) Push these into the brackets along the long pole, kind of has a ladder effect. You are done!! I use mine with a full size blow up bed, the elastic gets stretched but I can set it up easily outside, or in the livingroom. Enjoy Nancy