There is standing water in bottom when cycle is over

If there is a lot of water sitting inside the applicance, it's possible that the high water float switch has been activated and is preventing the dishwasher from running. Open the door, remove the bottom rack, dip as much water out of the bottom as possible with a shallow ladle or even tupperware container. When that is accomplished, shut the door and try to run a drain cycle. If the unit won't start, you may have to remove more water. You don't have to have the rack in place to run the drain cycle.

This is because you have a problem with the diswasher pump and/or pump motor. There should NO water standing at end of cycle.

None. You have a problem with either your pump and/or pump motor.

Try draino first then take it apart on the inside bottom to see what might be clogging it.

you may not be leaking out the bottom. Your stand pipe may be clogged. If the stand pipe has a slight clog in it, the stand pipe will over flow, and the water "looks" as if its leaking from the bottom... These pump faster than your old machine, so the pipe will back up faster... hope that helps

Water standing in the bottom of the tub is normal.
A small amount of clean water around the outlet on the tub bottom at the back of the tub keeps the water seal lubricated.

It is normal for a small amount of water to remain after each loadof dishes is cleaned.

Is the water clear or cloudy?
Is there an odor?

How deep is the water? Less the two inches?

Post back with your findings here. OK?

where is the water is it visible above the filter plate or is it in the bottom of the sump
if its in the bottom of the sump thats normal it will always leave water in the sump

try pressing the cancel/drain button.Do you hear water draining into sink freely?? if not i would disconnect drain undersink look for a clog right there first

if its new call your dealer its a warranty call