How to set the tax on a Casio HR-100TE calculator

Non-printing models (also applies to HR-8TE printing calculator):

1. Press [AC]
2. Hold [SET/%] key for about 2 seconds
3. Press [TAX+]
4. Input the tax rate
5. Press [SET/%]


Printing models (except HR-8TE):

1. Have calculator in "print" mode
2. Press [CA]
3. Hold [SET/%] key for about 3 seconds
4. Input the tax rate
5. Press [TAX+]
6. Press [SET/%]

I was able to order the part I needed at Americanperfit.com

Thanks

Printing models (except HR-8TE):
1. Have calculator in “print” mode
2. Press [CA]
3. Hold [SET/%] key for about 5 seconds
4. Input the tax rate
5. Press [TAX+]
6. Press [SET/%]

1. Press [AC]
2. Hold [SET/%] key for about 2 seconds
3. Press [TAX+]
4. Input the tax rate
5. Press [SET/%]

Press the CA button twice. Then push and hold down the %/set key until the 0 dissappearsd and reappears. Then type in your tax rate and the percent key (eg: 8.25%) and then press the TAX+ key. It should save the new tax rate.

I found this on the Casio site. I think yours is a printing model. If it is use the 2nd set of instrucitons. Hope it works...

Programming Tax Rate
Non-printing models (also applies to HR-8TE printing calculator):
1. Press [AC]
2. Hold [SET/%] key for about 2 seconds
3. Press [TAX+]
4. Input the tax rate
5. Press [SET/%]

Printing models (except HR-8TE):
1. Have calculator in “print” mode
2. Press [CA]
3. Hold [SET/%] key for about 3 seconds
4. Input the tax rate
5. Press [TAX+]
6. Press [SET/%]

1. Switch off the calculator
2. Switch it on again
3. Press and hold the tax button (set %) until the display changes
4. Enter the new tax rate
5. Press the tax button (tax +)

Any problems contact [email protected] - he emailed the solution to me and it has worked.

Pam

Printing models (except HR-8TE): 1. Have calculator in ?print? mode 2. Press [CA] 3. Hold [SET/%] key for about 3 seconds 4. Input the tax rate 5. Press [TAX+] 6. Press [SET/%]

1. Remove the top gray lid of the calculator
2. Insert paper through the back side slot near the power charger
3. Turn the calculator on print
4. Press FEED a couple times

step 1 pess the AC button step 2 press and hold for two seconds the % button step 3 press the tax+ button step 4 input 6 step 5 press the % button that should be the tax set you can check it is set correctly by pressing the AC button and then the tax+ and 6 should be displayed