I have a gaggia syncrony logic that has just come back from the repairers.! The coffee dregs are almost liquid whereas before they were solid patties & liquid is found in the drip tray after every brew. Can you advise as to why this might be

The unit requires a new grinder assembly

Check the 2 thermal cutouts located on the side of the boiler
Press to reset

Had the same problem, switch off, take out the coffee dispensing unit. close everything else up, drip tray, dregs box and front door etc then re apply power. It'll clunk and whir a bit then stop. Switch off and refit the coffee dispensing unit making sure it fits flush with the rear of the housing (you can check this by looking through the hole where the dregs drawer fits. power up again and it'll clunk and whir again as it resets the dispensing unit. I hope you'll find that it's ok now.

Check the site at importika.com they have a list of repair areas any one of them will have a spout in stock.

Chenk the back of the area for the drawer, there might be some grounds preventing the draw from going all the way in to tell the microswitch that it is in place.

You can check with wholelattelove or servicesunlimited.

Try this press the button for ground coffee then when it lights up press the coffee brew button, if water flows normally then the grind on the grinder needs to be adjusted coarser, if no water then the screen on the brew unit is blocked.

Check the edge of the container that goes in to the machine there is a small part that sticks out, it is possible that that piece is not touching the microswitch in the machine. Remove the drain tray and the dregs tray, check the corners of the machine for loose coffee grounds.

Need also to find height adjustable coffee dispenser, also need measuring scoop,brush and coffee dispenser with wrench.

If you look to the left side of where the dump box slides in you will see a opening in the case. This is the dump box switch. use a knife to hold the switch and turn the machine back on.

 

This will reset the machine to it proper position. I would recommend cleaking your machine so this doesnt happen.

http://cerinicoffee.com/clean_descale_coffee_equipment_instructions.asp