My roland vs 2000 says not found any drivers when i turn it on can it be fixed

Link to review below suggests possible fix.

https://rolandus.zendesk.com/hc/en-us/articles/201974669-VS-2480-VS-2480CD-VS-2480DVD-How-to-Connect-to-a-Computer

Your VS-2000 is showing symptoms of fragmentation--resulting in the unit freezing or failing to completely load. The only possible solution is formatting the hard drive. Formatting erases all data on the drive.

Note: If you have any files that you need to keep, you may contact our Roland Customer Support department (323-890-3740) to arrange a "Data Recovery" service. Our service technicians can attempt to recover any data that is in your hard drive. Customer Support is available M-F 8:30am-5:00pm Pacific time.

CAUTION!!! Formatting the hard drive erases ALL recordings and data on the drive. This includes any installed plug-ins as well. Be sure to back up all of your project data (recordings) and plug-ins to CD/DVD(s) before formatting the drive.

Unlocking the System:
1. With the VS-2000 powered off, press and hold the TRACK/STATUS button for track 4 and the FX 2 button.

2. With both buttons pressed, turn on the VS-2000's power. Continue holding the two buttons until the display has loaded completely. This can take several minutes.

3. Once the system has loaded completely, release the buttons.

Formatting the Hard Drive:
Note: The format steps below pertain to using the VS-2400's on-board LCD screen. If you're using an external VGA (video monitor), press and hold HOME and press F6 to switch to the on-board LCD.

1. Press SHIFT AND F1/PROJECT.

2. Use the CURSOR buttons to Select "IDE:0".

3. Press PAGE until "FmtDrv" is displayed above F2.

4. Press F2.

5. CURSOR to "Physical Format".

6. Turn the TIME/VALUE dial until "ON" is selected.

7. CURSOR to "Surface Scan".

8. Turn the TIME/VALUE dial until "On" is selected.

9. Press F5 (OK).

10. Press ENTER/YES twice.

go here http://www.supportdock.com/

the unit is going south time to buy a new 1 [it has a bad display panel]

The hard drive needs to be replaced. You can contact their customer service as to how to do this. It is relatively pain free and inexpensive as well.

323-890-3741

check the powersupply on the board itself ensure that its not blown.


thanks,
Nate

could you please be more specific


thanks,
Nate

have problem with vs 2480 anyone fixes  roland vs  2480

• Roland vs 880 or BR-8 ; Could this machine play more than eight tracks at the same time?...how? 

I have figured out a way to get around this problem without losing your data or sending it to Roland. I have three roland 2480s and have 4 hard drives. Buy another spare drive and when you load up to a different IDE drive shut it down, then put the old drive back into the unit and it will boot from the last known ide. Make sure it is not the same IDE # that was giving you the problem. You will get at your files but you better start to backup and defrag. I will not delete files on my roland unless I am willing to defrag. Buy an extra drive from a third party. You can see a company that sells this stuff on ebay and they are very good. "VS something store."