Bought new Infinity 8" speaker

I have the part you are looking for if you still are in need of it. Sweet-sounds Mark

Been there you will still have to cut.

In general higher speaker impedance is safer than lower impedance for the amp. Don't expect anything impressive re: audio output from a passive (unpowered) sub if your HTS says it pushes only 25 watts. Without frequency bandwidth and distortion noted the spec is virtually useless as a comparison.

The BU-1 is a powered sub that accepts either RCA Line Level or HIGH LEVEL amplifier power. If you use the latter, impedance is a non-issue because the input feeds the BU-1's internal amp, not the speaker directly. You should be okay.

Perhaps if we knew some specifics about the HTS we could do more than guess.

one of those wires on your speakers is the common ground for both sets of wires in your camaro, Just take the negative wire from both sets of wires and run it to the single wire on your new speakers. The other 2 are positive from each wire. good luck

I don't know what setup you might have, but you can get the user manual here.

if the impedance of the new speaker matches the impedance of the old one then i dont see why it wont work

Bleu + (pos) Black -

The soldering to the wires can go bad. Making the unit turn on and off. The vibrations of the subwoofer over time will cause them to work free. Then when in operation they will cause them to break contact again.

This is a very good system. I have the manual, please email me [email protected]