Won't move lights are flashing on the controller batteries are fully charged any help

1. Check the battery: Make sure the battery is fully charged and properly connected to the scooter. If the battery is low, charge it fully before trying to use the scooter.
2. Reset the controller: Turn off the scooter and disconnect the battery. Wait for a few minutes, then reconnect the battery and turn on the scooter. This should reset the controller and may fix the issue.
3. Check the freewheel lever: If the freewheel lever is engaged, the scooter will not move. Make sure the freewheel lever is disengaged before trying to operate the scooter.
4. Check the throttle: If the throttle is not working properly, the scooter will not move. Make sure the throttle is fully engaged and that there are no obstructions preventing it from moving.

The flashing red light means your battery is defective. 2 of 2 found this helpful. Do you? Seems to be more the battery's fault, indicating the voltage of the battery is off, and then the charger won't charge it anymore because of that, indicating that by the flashing red light.

more info needed, what chair and what controller? is it all lights or just some and if so how many? are there two sets of lights (one for battery one for speed)? with out this info can not help.

I will have a guess and provide the error info for the most common possibility 10 lights flashing "An excessive voltage has been applied to the controller. This is usual
caused by a poor battery connection. Check the battery connections."


If this helps please click the "YES" button to let others know it is helpful.

try leaving the camera on to drain the battery down, then try charging it again.. or could be a bad battery

my chair jazzy 1113 ats won't move.all the lights are flashing and the batteries are fully charged why are they flasng

Has your scooter been sitting idle for several weeks, or has it been connected to the charger 24 hours a days for a long time? If so, the batteries may have become damaged and will give you enough power to turn the controller on but not enough to make the motors run.
If the lights come on and are steady, the manual brake levers are in the drive position and the chair still will not move, I recommend replacing the batteries. If anything else were wrong, either the lights would flash or not come on at all.
I hope this information is helpful to you, good luck!

The chair will not move if the charger is plugged in. The flashes are normal with the charger plugged into the chair. The lights on the charger mean that the batteries have been fully charged. Red and yellow lights mean charging. After you unplug the charger from the chair (if off-baord charger, turn charger off or unplug from the wall) then unplug from joystick. after plug is removed from joystick press the on button and all the battery lights should be lit and when you move the joystick forward you will hear the electric bake release and the chair should move forward etc Hope this helps

The dead give away for a dying controller is the red light on the numbers will flash.

When you plug your controller in and hit your PS button, at the top you'll see a controller symbol and a battery icon. If the battery bars are moving then it's charging. When it's fully charged it will display 3 bars solid even when plugged in.

I've been wrong before; but I'm 99% sure you cannot turn off the system and have the controller charge. As far as I know the system must be on while charging the controller. From my experience it takes about an hour or 2 to get it fully charged.

Good luck and if i've helped you please give me 4 thumbs up!

Respectfully,

Don

Firstly disengage the drive levers and then "flick "them in fash.
Second pull out the large plug that is between them.
Check for damaged or bent or loose pins. press it home firmly .
I did this on my wifes chair and she zooms around.
All switched etc should be off during charge.

Lastly i fully discharged then recharged the battery to ensure no "battery charge memory".
To fully dicharge i shoved a small box between back wheels so to lift of ground and then a elastic band to hond controler on.