All hooked up dobble cked but water only trickles so ample supply

are your faucets turned on all the way??? what sizes are your hoses to the machine?? See if a larger hose will help.... but first pull out the washer and turn off the water behind the machine... disconnect the hoses,... get a five gallon bucket and see if you have ample water pressure into the bucket....if not, your faucets may have calcium deposits inside restricting water flow.... there fore both faucets may need replacing. Some areas of our country have high levels of calcium in the water, and if this applies to your area, this may be your problem. Some hoses have a small screen at one or both ends... they may be clogged..... if so soak the ends in vinegar for half an hour, most of the calcium should be dissolved. Hope this helps. Good luck.

there is a valve where the hoses hook up to the washer its probably going bad

Look for the obvious-take off the screen. Then you may have to venture into the faucet itself. If you have galvanized pluming, every time you shut the water off, scale will fall int the center of the piping without pressure and then when you open the faucet it tries to flow through small orifices.

Side like a water supply issue or a kinked line. Good pressure at first then weak pressure after a short time is a restriction in the water flow.

You need to hook a meter up to the valves and see if they get voltage when they are being told to open

Turn on the headlights and see how bright they are.
How old is the battery?
Check the water in the battery,
If the battery is faulty a trickle charger may not supply enough power to charge it at all.
Take the battery to auto zone and have them check the battery.
Good Luck

use the hot water supply to the washer.You can replace the element if you want but i never do....the hot water supply is ample hot enough....clean your filters...if the cycle is not changing from wash to rinse and so on your timer has failed.

Check water supply make sure you have ample water and not a kinked connection from supply. It is a common failure on Amana to have a defective Filter/Head assembly.

check for proper flow and pressure on water supply line

you can try cleaning the filter at hose end, where it hooks into the unit.make sure your cold awater supply is good.