Maytag MAV-35 Roars during spin - Washing Machines

What does it do when it gets to the spin cycle?

Does it not spin just in the final cycle or not at all during the wash cycle? Also, does the wash cycle agitate normal?
Regards,Richard

This is most likely a problem with your drain line. Check to make sure it's not filling with water and that there is a gap around the line in the drain hole to prevent vacuum lock. Give the hose a good shake and see if that dislodges any stuck water.
You could also have something caught in the valve which is preventing it from opening and closing properly.

Honestly get a new washer if you got 7 years out of an mav your ahead of the game worst machine maytag ever made, you need a timer but i wouldnt invest the time or money on an MAV

sounds like a transmisson problem expensive to fix

1) Make sure valve is open all the way 2) some machines have a screen inside of the hose hook up which could be clogged. 3) last check to see if it is the hot or cold by switch your selector switch on your machine to hot then cold. If one of these positions eliminate the noise then the valve in the machine is bad.

there is no adjustment most of that paticular machine had 5 to 10 yr part warranty on transmisson call your local maytag store

hi thanks for the question with any washer if you use a hi sud zing detergent it really slows down the spin cycle check this just fill & drain 2or 3 times use some veniger try this thanks the appliance doc

Sounds to me, your belt is slipping. The motor tensions the belt with springs. The motor slides in grooves to keep the belt tensioned. These grooves get gooked up with dust, dirt, rust, slime, etc. Move the motor back and forth a few time to clean the grooves. Also spray some lubricant on it to help clean it and make it slide freely. Be sure both sides slide back and forth in their groove. After doing this, your belt should stay tensioned enough not to slip during the spin cycle. No tools needed and even the average moron could do it. Hope this helped.

this is my experience repairing the maytag washer Atlantis mav series 9750 aww, I had to replace the spin bearing since it was making a jet engine noise when it was spinning out the water. its not an easy job for my 1st time taking this machine apart, you literally take it all apart to get to this bearing, but now I can show how to do it with pictures making it easier for you to do it. even if you have to replace something other than the spin bearing, this how to tutorial will show you how to get to most of the parts in this machine
tutorial located here tutorial located here https://sites.google.com/site/maytagwasherrepair/maytag-washer-repair