Kenwood 50W x 4 Apple iPod -Ready MOSFET CD Deck with Detachable Faceplate Logo
Posted on Aug 09, 2008

Get no sound from rear speakers WITH ipod

I am using the usb on the front of my receiver and I get no sound from the rear speakers. They all work when playing the radio. Just had the system installed. Kenwood head unit. Infinity 5.25 component in the front and Harmon Karden stock woofers in the back.

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

  • Contributor 1 Answer
  • Posted on Aug 10, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Joined: Aug 10, 2009
Answers
1
Questions
0
Helped
157
Points
2

I have exactly the same problem - don't work with CDs either, just radio. Just installed the deck yesterday. Help would be appreciated. Have been through the manual front-to-back.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
8answers

JBL Radial -iPod audio system

It should produce sound from al speakers, I see if I can find a schematic.
1helpful
1answer

I am trying to install a Pioneer 3200UB. I purchased the harness and have power to the radio. I have no sound comming out of three of the speakers and a faint sound out of the fourth. Any suggestions.

Try Checking to see if you Have the positive and Negatives for the speaker's hooked up right, and make sure that you don't have a Negative to a front speaker and A positive going to a rear Speaker
1helpful
1answer

5.1 Dolby system does not work with the T.V.

Solution: connected the rear right and left wires to the Front , left and right wires......................and everything works the way I anticipated without any technical problems....... the woofer works on a separate circuit, so I continue to receive the "low" frequency..
0helpful
2answers

No surround on Denon AVR-485

Hi you must put the amp into prolgic mode this is fed by a stereo siganal the rears will sound vague and hollow that's all you will get this willnot work with 5.1 or 7.1 good luck
9helpful
3answers

Only 3 speakers work!

I took the bottom off my go play to have a look inside, the internal port is connected to one rear speaker grill and the other is blanked off, so no sound will come out of that one.
0helpful
1answer

No sound from subs and rear speakers...

Make sure the Ipod is plugged into the AV input source. Then you may have to go through the menu to select AV1 or AV2 input. This should take care of the problem. Good luck
0helpful
1answer

NO surround sound coming from our harmon/kardon speakers when set up to our onkyo tx-sr601 receiver. wires connected in correct areas, front left, right and center speakers work, subwoofer works. setup for...

So your saying that you have no rear channel. Some recivers use a single stereo output ic for both sides on the rear speakers. you could have a defect with this IC . Anther thing Im sure you check3ed the obvious ie : the switch is on suround sound? If there is a front to rear fader is it in the middle? Good Luck
Not finding what you are looking for?

167 views

Ask a Question

Usually answered in minutes!

Top Kenwood Car Audio & Video Experts

xxxxxx xxx

Level 3 Expert

5117 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you a Kenwood Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...