smithgrvtn,
It is possible to get your TV1 remote to work TV2, but it would have to be a model 6.0/6.3/6.4. If it is not one of those models you would need to have a remote ordered and sent out; then it would work. If your remote is one of the above models; I have included the steps to get that done.
Changing Remote from UHF-to-IR and IR-to-UHF:
1.) Verify correct model of remote and it is IR/UHF compatible. Remove tab from bottom of remote. For TV1: Green Tab with Green 1 in it. For TV2: Blue tab with 2 and black UHF in it.
2.) Push correct tab into remote, and go to your main TV.
3.) Access System Information either with a remote, Sys Info button on front of receiver, or powering it off and pressing the up arrow.
4.) Press and hold the gray SAT button until all buttons on top light up. Release and while the light is blinking enter a number between 1-15 and press Pound(#)
5.) Press Record 3 times and check to see if the address changed to the number you chose. Verify remote works.
If you have any other questions you can let me know here; or at
[email protected] and I would be happy to see what else can be done!
Tommy Faust
DISH Network
×