My whirlpoolduet dryer is on control lock how do I unlock it model # gew9200lw1

Can possibly find it at searspartsdirect.com. What problem are you having with heating element?

Whirlpool Dryer Model GEW9200LW1 Fuse Thermal Fuse Breaker Parts

If all ur other wires are connected already u should only have 2 wires left to attach? if the heads on each wire are not different u can just attach them to either connection on ur thermal shut off and u will be alright. 1 wire usually attached to the heating element if u follow it thru anfd the other goes up to the control board

if you dont have enuff power it wont heat...and it could also be the moter or control board

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

The model number tells only the year that model is introduced but the serial number tells the year and the week of production.

First disconnect the power to the dryer by unplugging it from the wall. Then remove the 3 screws on the lower panel of the dryer. This should expose the heating element in a metal housing on the right side of the dryer. Disconnect the 2 wires going to the heating element and slide it out of the housing. The heating element part number is 3387747.

you have to push and hold the button that has the lock symbol next to it. i think on this it is on the far right hand side on the control panel.

I'm not familiar with the specifics of this machine, but the bezel and Console Electronics (the subassembly clipped to the bezel that holds the circuit boards and buttons) on our Whirlpool GEW9200LW1 is a poor fit, and pressure on the bezel itself can activate the End of Cycle button, and subsequently lock the controls.