Nitro 482 2 channel amp.....what size fuse goes in the fuse holder on the amp

Request the diagram from Nitro.

Disconnect all speaker connections and rca cables. Leave power, ground and remote wires intact. Try turning on again. If you still have a protection light your amp is faulty. Hopefully you have warranty. More details .A thumbs up would be greatly appreciated if this answer is helpful to you.

it needs repaired, it has an internal short

you can put a jumper on that, just make sure you had to make an external fuse with the holder with the correct fuse ampere rating

Hello taona80,

If the 1,000 watts is RMS, I'd recommend an amp in the 750-1,000 watt RMS range, perhaps like the Alpine MRP-M1000 or Rockford-Fosgate T1000bd. If the 1,000 watts is peak power, the subs continuous (RMS) power handling is much lower, probably 300-400 watts. In that case, I'd recommend the Alpine MRP-M500 or Rockford-Fosgate T500-1bd.

the amp you have will do the job depending on how may ohm you sub is and can you amp stable to handle low ohm's. you should also check your cabling to make sure its for about a 1500w amp so you dont lose any power

Disconnect all speaker connections and rca cables. Leave power, ground and remote wires intact. Try turning on again. If you still have a protection light your amp is faulty. Hopefully you have warranty. Dou .A thumbs up would be greatly appreciated if this answer is helpful to you. http://www.nitrobmw.com/

sorry to have to tell u this but you blew your amp or just the channels this happens when you dont have the ohm rite for amp and speakers

check fuses and remote wire at the head unit. must have a good ground at amp.

left + goes to the amp left - goes to the + on the right sub and the right - goes to the amp try that

rate pls