I have a model Jensen MCD 5110 and the face plate keeps flashing and all the stations look like they are searching for a channel..The other problem is the volume won't go past number 12 out of 46 and I can barely hear the music..

Place your question or part of it in YouTube. I'm sure there's a similar problem with a similar model.

I don't know much about marine radios. I am a ham radio operator, but they are much the same, if you do not hear any static (with squelch control turned down), then I suspect you are correct about the antenna. It could be the antenna itself, or the coax line to it, or the connection point at the radio or at the antenna. You're stuck without being able to remove it. If you do and find nothing at the radio, you'll need to check the connection at the antenna etc. Good luck.

I have a face plate if u still need one

You hold down the number on the face plate for about 5sec. or till it flach where you want the station to be set.

Do you still need the face plate for a 5110? I have one with case. if so e-mail me @ [email protected]

Take off the face plate and it is located in the lower left corner

Hi Troubledinny,

I have had the problem before and it was the Tune button had gotten dirty inside the face plate. I got a can of Air from Radio shack, and blew out behind the button. You may have to open the Faceplate to clean yours.

just turn the changer on, make sure it is playing a disk, (and you know whats playing) the press the scan function on your radio til it picks up that signal and lock it in.

try ebay