I have one problem with toshiba b-sa4tm printer.in that printer the communication is not working.what is the problem.

hi

find link for user manual for toshiba

https://www.manualslib.com/manual/180471/Toshiba-B-Sa4tm-Series.html?page=86

the error code means Communication error between copier and PFC.Check cable from pc to printer.

You may have a mis alignement of the detecting cells.
The arrow on the top part of the cells should be on the round hole on the bottom part. (Green plastic mecanism)

F07 Communication error between boards (LGC and SYS boards)

Firmware is where I would start along with the wall power.

If this isnt work, replaced logic board and updated firmware. Machine will must works perfectly.

Hope this helps.

Communication problems between the printer and the host.
Check the cable or the type of parallel interface selected in the parameters of the printer

Solution :
1. Cheak ur communication cable ?
2. re-install the softwear
3. when u command print by the copier what it says ??

I think it'll be the communication problem may the the cable or the softwear contol menu, u have to read the user guide 4 this printer and learn how to connect and apply this from the copier.

On the host pc that connected to the MFP, check the paper size setting under the driver properties.

The message "no communication between printer and computer". some times indicates that the cable you're using is faulty or the port selected is not the printer port you've connected your printer to.cheers.

check the status of usb port on device manager, install the updated usb driver

Hi: I've had a lexmark printer 1410-which would find that communication with the printer error too.

I found out that you have to install just the software (CD) first.
I believe it will tell you when to hook up your printer & turn it on. I now have a brother 6 in one and I had to do the same thing. Hope it works for you.