To much oil everytime oil is checked - Honda Electrical Supplies

Engine light?
Check engine oil level manully if it is safe operating mark also its vescocity(thickness) oil must not sitk to thumb and foure finger if a drop is put between those fingers. replace oil with the same grade/type if it is thick along with bypass and oil filter then check.
if the oil is good at the first just reset the electrical by disconnecting battery terinal for few minutes.

drain your gearbox oil and also please check the clutch plates for the bike and also let me know what mileage you are getting .

Check the hose going to the pvc valve,could be leaking.

Color, dark/oil, red/tranny. Also check trans fluid level.

If its a 2.0 they are known for burning oil and not smoking
don't know what weight oil you use but with this problem
20-50 will help a lot

Hi Friend:
Check to See if your air-temperature sensor that regulates the amount of vacuum signal that is applied to the servo motor:

The worst Problem is Blown Head Gasket will cause a Loss of Coolant and will cause the White Smoke out of Your Exhaust.

Check your Raditor for signs of Oil in it.

And Double Check your Oil to see if there are Signs of Water In your Oil.

Sounds like you Have a Bad Head Gasket or a Cracked Block That is letting Water to get into your Oil.

It sounds like it Not a Large Area of Head Gasket Failure as of Now.

But it Will Get Worst. Replace your Head Gaskets. And Check your Heads for Warpage and Cracks.

Thank You For Using FIXYA From d_hubbs

P1684 - Less than 50 Key On's.
P0302 - Misfire at Cylinder #2
P1493 - Ambient/Battery Temperature Sensor Input voltage too low.
Oil Light with the correct oil level = Oil Pressure/Sending Sensor.

you put too much oil on your engine, 2.8L without filter change. 2.9L with filter change is the recomemded if you exceed you bike will spit the excess oil sometimes the oil goes to air cleaner have your air cleaner check and cleaned

Check your oil make sure that the water is not mixing with the oil

try resetting