The area between the glass on microwave oven door and the glass on then displays steams up while in use.

There is a small vent hole at the bottom of your oven door that is made to allow you to reach a brush up to clean the glass.. It sounds like your stove seal isn't sealing.

Cooking food in there will cause steam as the microwave heats the water content in your food to make it hot. This will mean some escapes and will settle somewhere it can find cooler than the rest of the unit

There should be glass.

GE Customer Service is here.

steam between glass doors of microwave

Look and see if there are screws holding the inside of the door to the outside of the door.
If so, remove the screws and the door should come apart, and may be cleaned.
God bless your efforts.

It is not advisable. The door is a critical safety part of the microwave oven. The glass being gone will allow heat in areas of the door not designed for heat. The glass also is a support for the safety mesh that contains the microwave energy to the cavity.

Your glass seal has failed and I doubt it makes sense to replace the door. Yes, it can be dangerous as the moisture becomes worse you risk the chance the glass could over-heat and blow out. Sounds like you need to replace it, sorry!

On GE models, "SENSOR ERROR" appears on the display when:

• Using the sensor feature, the door was opened before steam could be detected. Do not open the door until stream is sensed and time is shown counting down on the display.

• Steam was not detected in the maximum amount of time. Use Time Cook to heat for more time.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Any water in between the glass and the door should evaporate eventually.
I wouldn't advise trying to open any seams in the door or removing the glass to get the water out as that would permanently damage your microwave.

Your models manual talks about steam/water condensation that gets trapped between the door and the glass and what to expect:

http://www.fixya.com/support/p113437-emerson_mw8107wa_1000_watts_microwave/manual-11318

First: do not use this unit with the glass improperly installed. Often, these installations use double sided foam tape, available at any hardware store. Carefully remove the screws in the door being careful to catch the glass. Clean the area where the tape will go with glass cleaner or alcohol. Allow to dry and buff to remove oil and grease. Install the tape and glass. Reassemble.