HP Proliant Server DL380 G4 wont boot no display

Use SmartStart CD Media ver 7.5

Clear NVRAM using Maintenance switch SW6 button

Just Clear NVRAM (by SW6 maintainance switch )/ else systemboard has to be replaced

Hello, I think you might find more information on starting up the DL380 G2 at the link shown below:
http://h20566.www2.hpe.com/hpsc/doc/public/display?docId=emr_na-c00972124

Also, the replacement instructions, in case it needs to be replaced, (and relevant troubleshooting info) for the 5i controller are found in the link here :http://h20566.www2.hpe.com/hpsc/doc/public/display?sp4ts.oid=316587&docLocale=en_US&docId=emr_na-c00688182

Please first make sure that you are using the proper startup boot disk for the server before entering the CD ROM option from the boot menu. Also, check the front panel of the SCSI drives for any errors or blinking LEDS that correspond to an error code. You can run a diagnostics CD/DVD that arrived with the manufacturer's pack to detect any raid issues on startup.

If you are still facing difficulties with booting up the server, you can find a video for replacement of the appropriate scsi drive here if you are still facing any issues of your scsi drive. Try a different hard disk or check the relevant diagnostics to verify whether is the controller or the drive that complicates the booting of the server

For more details check the scsi manual in the link below (section "FBWC LEDs" , pages 15-17).
http://h20564.www2.hpe.com/hpsc/doc/public/display?docId=emr_na-c04441382

Connect the keyboard, mouse, monitor, network cable and power cord. press the power button on the front panel of the server. If the OS is installed the server will boot.

Make sure the BIOS is fully updated from the HP website. Most DL3-series servers supported booting from an external USB cd, try F10 or F12 at boot in order to bring up a boot menu.

make sure there is no disk in cd rom drive if there remove it and also check the amber led in front panel which is indicating the problem still if you are not able then open it and check the ram. And the power connector in motherboard and also the cmos battery or reset the bios.

Hi,
Is your server under carePAQ/ support by HP.
Please go to the System Settings/BIOS of the server by pressing F9 while booting. Check for error messages.

Please check for the processor support matrix also. You may want to try upgrading the motherborad firmware berfore loading this proc.

Cheers,

To enter the BIOS of a ProLiant DL380 you have to press "F9"

Try to update the firmwares. Maybe the threeshould of the fans are incorrect. A new firmware can correct this problem.

Let me know if this post helps