Hi!
Welcome to FixYa!
You can use these codes to program the Dish remote control to your Sanyo DS32920:
542, 589, 590, 591, 592,609
You may also try Power Scan Instructions. Please follow the steps bellow.
1. While at the TV locations (TV1 or TV2 depending on which key is
installed), point the remote at the TV. Press and hold the TV MODE
button on the remote until all four MODE buttons at the top of the
remote light up.
2. Press the RECEIVER POWER button on the remote.
3. Press the UP ARROW on the remote, about one press every two seconds.
Stop as soon as the TV turns off. This process may take several
minutes.
4. Press POUND (#) on the remote. The TV MODE button will flashWhat is my tv code - lor04_4.pngs.
5. Press TV POWER on the remote to turn on the TV. Press VOLUME on the
remote to confirm the remote controls the TV. If this What is my tv code - lor04_5.pngrk,
return to Step 1.
Keep me posted.
Thanks.
Lor04
I had a heck of a time with this same issue a few months ago. The issue is that you don't plug in a code to the remote for each TV. The dish network remote auto programs. follow the instructions in the attached link and your remote should be working great shortly.
http://www.ehow.com/how_4771669_program-operate-tv-dont-code.html
Cheers.
620 views
Usually answered in minutes!
×