What does E3 meam on gorenji dishwasher - Gorenje GV 62110 23 in. Built-in Dishwasher

All questions need 'make model (what it is)' and you only have 1/3.

E3 is water too high or too low, or hot water related not hot enough or vibration depending on maker.

Error message E3 in integrated compact dishwasher indicates too much inlet water and/or a leak.
Oct 7, 2019

Compact dishwasher displays error message E3 - Electrolux

Error code E3 on a Hobart LXiH sanitizer/dishwasher typically indicates a problem with the water fill system. Here are a few things you can check to troubleshoot and resolve this issue:

1. Water supply: Make sure that the water supply to the dishwasher is turned on and that there is adequate water pressure. Check for any kinks or blockages in the water supply line.
2. Water inlet valve: The water inlet valve controls the flow of water into the dishwasher. Check to see if the valve is open and that there is no debris blocking the inlet. If the valve is faulty, it will need to be replaced.
3. Water level sensor: The water level sensor is responsible for detecting the water level in the dishwasher. If the sensor is not working properly, it can cause the dishwasher to display an E3 error code. Check the sensor for any signs of damage or debris.
4. Water pump: The water pump is responsible for pumping water into the dishwasher. If the pump is not working properly, it can cause the dishwasher to display an E3 error code. Check the pump for any signs of damage or debris.
5. Control board: The control board manages all the electrical functions of the dishwasher. If the control board is faulty, it can cause the dishwasher to display an E3 error code. In this case, the control board will need to be replaced.

Error message E3 in integrated compact dishwasher indicates too much inlet water and/or a leak.

E3 error in free-standing compact dishwasher
1. Contact an Authorized Service Center.
Error messageE3in free-standing compact dishwasher indicates malfunction of heating element.
We recommend requesting a visit by a service engineer.
E3 error in integrated compact dishwasher
2. Contact an Authorized Service Center.
Error messageE3in integrated compact dishwasher indicates too much inlet water and/or a leak.
We recommend requesting a visit by a service engineer.

Check the route of the drain pipe and check for blockages.

The E3 error code is not a defined error for this dishwasher. If you are sure it is E3 then best option is to give the controller a reset. This is done by


Press the Delay Start + Normal + Power keys at the same time for two seconds to enter Service Inspection Mode.
- "ALL" is displayed for the first three (3) seconds and then "t1" is displayed.

Press OFF at this stage. Do not attempt to run the inspection as this could damage the dishwasher unless you are familiar with the what each mode does.
If the Error E3 keeps coming back then call the Samsung technician.

the E3 error is a result of water temperature not getting to a nominal value within a particular time. This could be caused by several factors like heater faulty, wash pump not working well, wash arms not circulating water as required. Need model number to help you further pin point if possible.

Refer this site for 60 inch dishwasher and this site for 45 inch ones.

E3 error arises due to the malfunction of temp sensor or the heating element. Check for the thermostat.

The E3 code means - Longer heating time.Not reaching required temp. Cause - Malfunction of temp. sensor or heating element. Good luck !

i need your serial num its important 17