Water dispenser is working very slow the water is flowin very slow.

I'd replace the valve that hooks to the water supply.

You will need to replace the water inlet valve. Here is the part to order.

What ended up fixing it?

Hello there, when new filters are fitted usually they are expected to spurt for a little bit before they normalize and begin to flow properly. Dispense water continuously for 10 minutes. This usually arises when the flow of water through the unit not being allowed through properly and usually takes the new filter a couple of minutes to get accustomed to the water flow and get water circulating through all its components hence the spurts. Alternatively you can check to ensure that the water supply is turned on full and the filter is properly fitted. If all of these are in place then the dispense mechanism might be faulty.
Hope this support has been helpful?
Thank you for visiting FixYa.

Sounds like your water valve may need changing, and has filled up with sediment, slowing the water flow.

Put the old filter back on , if water was fine . You never change filter just because a light comes on telling you to . The change filter light comes on after time or usage of dispensor .( Good way for manufacturers to make extra money ) . Change the filter only when water flow slows from dispensor .

you need to change the water filter, usually around $35.00.

hi, this can be because of the filter. when the water is flowing threw the filter, it is sent threw many channels inside the filter before it reaches the dispenser. this slows it down a bit. this is quite normal but, if it's slowed down to a dribble, i suspect a water valve malfunction or you may need to change the filter.

Hi!!! you seem to have a bad water valve in your refrigerator.change your water filter and the water valve on the back on the frig..