I have a ProScan 80 series, 32 inch TV. I turned it off, and now it won't turn back on. nothing can make it power back up

Easiest TV repair How to Fix Power TV turns off freezes or won turn on

Try hard reset, unplug TV, wait 10 min. and plug back in.
. You may have to reset your setup configuration back to how you preferred. hope this works for you

There should be a short circuit to any of its internal board. If power supply switches on, and TV do not work, check the main digital board for fault. Try this link. http://electronicshelponline.blogspot.com/ There are more than two thousand and five hundred posts. All are related to television and other domestic electronic equipment service help.

It appears to be a 32 inch.

Some questions:

Does power light come on and if so what color when set is off?


Were you having any problem before where you had to turn set on several times to get it to come on and stay on?

I am here to help you.

It appears to be a 32 inch.

Some questions:

Does power light come on and if so what color when set is off?


Were you having any problem before where you had to turn set on several times to get it to come on and stay on?

I am here to help you.

This problem usually occurs as a result of overheating in units. The unit is meant to be placed in a location where enough breeze will be accessible to avoid over heating in the unit.
Hope this solution has been helpful?

This is probably a tv with the "ctc-169" chassis. The BEST modern chassis RCA built. I own 2 of them that I USE, one is a 32" CONSOLE, a lot like your 27" set the other is a projo. I would keep BOTH of them ANY day--over ANY of the cheap, unreliable, fragile flat--panel sets today!!

FIX your set!! If the picture was good--it still will be--these sets had GREAT tubes in them. Most likely--a power supply isue with a couple of caps in the power supply, perhaps the controller chip for the chopper transistor, nothing likely serious. Probably about 150 repair--or less.

The PS50700 uses the 195 series chassis. The most common cause of the set not starting up is a shorted flyback (high voltage) transformer. Sometimes a shorted flyback will also cause the horizontal output transistor to short too. These parts need to be tested and/or replaced by a tech familiar with the RCA 195 chassis.