Paper is pulled through crooked printing is not straight. how doyou clean the rollers?

Hello, Vicki -

I found a HP discussion board where someone posted the same question, but for a different model HP printer. See all the replies here:
https://h30434.www3.hp.com/t5/Inkjet-Printing/Paper-feeding-in-crooked/td-p/6334779

Best wishes.

Most likely to be a page feed problem, look online to clean page feeder rubber rollers.
Try here for the pdf manual which covers problem with jams and skewing
http://www.hp.com/ctg/Manual/c00264334.pdf

When the paper does not feed straight, dirty or sticky rollers can cause it to jamb or crinkle, also failure to remove all traces of paper from a previous paper jamb will cause further paper jambs.
Check for tiny pieces of at the edges of the rollers, and remove these pieces of paper. The rollers may be dirty or sticky and causes the paper to not feed straight.
Try cleaning the rollers with methylated spirits.

When the paper does not feed straight, dirty or stickyrollers can cause it to jamb or crinkle, also failure to remove all traces ofpaper from a previous paper jamb will cause further paper jambs.
Check for tiny pieces of at the edges of the rollers, and remove these piecesof paper.The rollers may be dirty or sticky and causes the paper tonot feed straight.
Try cleaning the rollers with methylated spirits.

When the paper does not feed straight, dirty or stickyrollers can cause it to jamb or crinkle, also failure to remove all traces ofpaper from a previous paper jamb will cause further paper jambs.
Check for tiny pieces of at the edges of the rollers, and remove these piecesof paper. The rollers may be dirty or sticky and causes the paper tonot feed straight.
Try cleaning the rollers with methylated spirits.

When the paper does not feed straight, dirty or stickyrollers can cause it to jamb or crinkle, also failure to remove all traces ofpaper from a previous paper jamb will cause further paper jambs.
Check for tiny pieces of at the edges of the rollers, and remove these piecesof paper. The rollers may be dirty or sticky and causes the paper tonot feed straight.
Try cleaning the rollers with methylated spirits.

Something is making the page feed crooked. Are the "fences" beside the stack of paper up against it to prevent it moving sideways? Also check that the feed rollers are clean and have good friction. Plain water on a cloth will usually clean them well enough to feed properly - just be sure the rollers are dry before you reinsert paper. Use a cloth, not a paper towel, because paper leaves fuzz behind, making the rollers slick. In more severe cases I sand rollers, then clean them, but you need to be careful not to get sanding debris all over the printer.

sounds like something jamed in the rollers like a pin etc

The paper feed rollers are dirty and are pulling the paper in at an angle.
Could be from high % cotton paper or sticky label printing.
Clean the "pickup" rollers with eyeglass cleaner (not Windex).

make sure roller is same height as other, then clean that roller with an eraser. have a great day please rate bama46, thank you