My suspension (airmatic ML 350-2006 ) is always failing and showing the "visit workshop" message. please what is the solution?

DEALER OR SPECIALIST QUESTION. DID U GET ANY ANY RECALL MESSAGES? GOOD LUCK

http://www.mercedesmedic.com/mercedes-lowers-drops-parked-air-suspension-self-leveling-problems

leaking airmatic suspension and car is too low to safely drive.

It will have to be tested at a dealership. It is most likely the strut assembly, but occasionally the air pumps go bad.

Hi. Thanks for your question. For assizstance on EPS light in 2008 ML 350 You can visit https://www.reliable-store.com and download the entire workshop manual which includes all the information along with the diagrams which will help you in checking lights. Good day!

air suspension on mercs are very expensive you can change all shocks for standard one if you need to

Hi , on this model x5 it may be worth having the ride height set correctly before thinking that there could be a problem , this can only be done at a bmw dealer , regards mark.

You must go to the dealer workshop for replace shock in your car, after replaced shock in your car must need to re calibrate the airmatic suspension through Mercedes diagnostic CPU otherwise It won't be working properly,

The suspension has a leak somewhere and/or the airmatic compressor has stopped working properly. You need either the Mercedes star diagnosis system (SDS) in order to access the suspension control module to tell it to raise the vehilce or you can try to trick it by jacking up the car so it thinks it's sitting at the correct ride height. But as long as the display reads a warning it won''t allow the airmatic compressor to run.

ABS--BAS

Most likely cause is the 'stop lamp switch'
It is a electric switch located on the brake pedal inside the car, about half way up on the brake pedal.
Pretty cheap too, I think the switch is only like $25 bucks.
2 connectors on the switch and then it turns out.
hope that helps