How do I remove the selector knob on washer

Good afternoon friend, that's a great question!

I understand that you are trying to replace the selector knob on your Frigidaire washer, GLTF2940E. Normally this is not a DIY job and we would recommend having a technician come out to the home in order to properly disassemble your front panel and replace the selector knob as needed. Hope this is helpful. -Matt

Try this link Typical timer replacement

Remove top of washer then Remove timer knob then (2) screws behind knob, un- plug timer connector and replace of course always unplug machine First

no the solution is that the drain pump is dead and needs to be replaced open the front panel of the front loader and locate the filter and clean and also remove!!

Disconnect power to machine. Remove bottom front panel by removing one screw from each lower corner of panel. Have a few old towels ready to catch water, and remove clamp at pump inlet. Fish out all the coins or other objects from the rubber boot pump inlet. Reassemble and test with the panel off first. If all OK and no leaks, replace panel.

There is no acutal filter on this unit...You cab remove the back panel to access the drain pump ...Or tilt the washer back and access it from the bottom...Remove the drain hose from tub to drain pump...(careful of flow of water from tub)...Check the hose for any blockage...If no blockage then your pump is bad..

I have a GE front loader and this problem drove me nuts after spending $$$$ and having this problem only after 2 years of operations! Please check the filter screen. Remove the screws that hold the front panel to the body. There will be water coming out, so have some towels and a pan to collect. Once the panel is removed, there is a knob for the filter screen which needs to be turned to remove. Have your pan ready because it will leak. You can clean the screen by hand removing the gunk (keep the money for your efforts, however :)) Replace the filter, turn to tighten, replace the front panel and screws and run the washer through a short cycle to check out everything and make certain there are no leaks before you walk away. Good Luck!

Unplug unit, Plug back in.Rotate control knob to correct Model number.Press and hold start key till beep is heard,press power key to reset

I believe the selector knob on a Whirpool just has to be turned counter-clockwise with the selector pushed in. It will spin off the shaft and then the outer indicator dial will pull off. The shaft also has a keyed slot that will only allow the dial to be removed and installed one way, so there should be no question as to how it goes back on.

Was there a reason as to why you are removing the washer selector knob? If this is a simple matter of replacing a broken water temperature selector, you shouldn't have to remove any of the control knobs to gain access to the selector. The entire front panel comes off by removing the screws holding it in place. That way you can access the broken selector from behind the front panel much easier. Just remove the panel right above the washer top (under the dryer) and it should expose the front panel mounting screws. Remove these screws and the front panel comes off. Just make sure the unit is unplugged before you begin. I hope this helps you. Let me know if you need further assistance.

replace the drain pump.and 2 remove the control panel u need 2 remove the 3 screws from top cover from the back