WE HAVE A MAYTAG QUIET SERIES 400 OUR DISHES COME OUT NOT CLEANED. WHAT DO WE DO

https://www.hunker.com/13407741/how-to-clean-a-maytag-quiet-series-dishwasher-filter


How to Clean Maytag Quiet Series Dishwasher Filter Hunker

Look for plugged or restricted drain system and screens. Look at spray ports for debris.

Our whirlpool gold quiet partner iii dishwasher is not working well . It is not gettting dishes cleaned soap left on dishes on top primarily

My Maytag quiet 400 series is doing the same thing-buttons aren't responding or working. And now a second problem...it has become very loud and sounds like it is chewing up all the dishes.
PattyQ

under the unit where the water line connects,this is where the filters are.disconnect the water line take the fitting off that the line was hooked to,screen is there under fitting.

We also have a Quiet series 100 and had the same problem, the dishes always came out dingy or with food all over them. My washer is about 5 years old and worked well for about 4 of them but the last year has been doing a poorer and poorer job washing the dishes. I finally broke down and removed the racks and all of the plastic parts from the inside of the washer. Doing this revealed that the groves in the under side of most of the plastic parts was clogged with food and debris. After a good scrubbing with water and a brush then reassembly it worked like a new washer again, cleaning the dishes very well and the best part is it saved us about $700.00 for another washer.

Maytag Quiet Series 400 dishwasher model MDB7601AWS

Go to;
http://shared.whirlpoolcorp.com/product_literature/search_results.jsp?searchTerm=MDB7601AWS&siteCd=MT_EN_US

and clink on any manuals you want.

A water softner will not make the dishes any cleaner, it just makes it so they don't have water spots on them.
If the dishes are dirty, it is most likely that the nozzles (holes) in arms may be plugged.
Also check to make sure you are getting plenty of water to dishwasher. Make sure all water valves are full turned open.

If the control panel does not work all the time, it is very likely you have either a shorted wire, or a fualty main board which is very common in newer machines.

Very common problem is soap build up in these machines. Try putting it into a wash cycle with no dishes, and no soap. Let it wash for about 5 minutes, and then open the door. If you see alot of soap suds, then soap build up is the problem. Try doing a couple loads with no soap, and no dishes, and throw a cup of vinegar into the machine halfway through the wash. Repeat as necessary. This should solve your problem.

try using less soap and make sure the dishwasher is filling with enough water.