What are the tips of sodoku - Excalibur Electronic New York Times Sudoku

Steel tip darts are mostly used with bristledartboards. Steel tip darts have a very sharp steel point to stick in the fiberof a bristle board. Soft tip darts are mostly used with electronic dart boards.Soft tip darts have a flexible, plastic tip on the end to easily lodge into theholes on electronic dartboards. I prefer the soft tip because it's usuallylighter than steel tip darts.

Writing a tip on FixYa is simple. Sign in and visit your My FixYa homepage. Visit the answer tab and click the "Write a Tip" link located on the left. This will navigate you to the Write a Tip page where you can enter your tip.

I am assuming that you installed a new tip. Note, the tip ends have to be 3/8 of an inch 90 degree bend so that when you insert the tip leads into the barrels, they go into the small holes in the barrels. Also note, the nuts to tighten the tip into the gun have to be installed onto the tip leads before bending the leads. Now when the tip is installed this way, the nuts tighten and hold the tip in the barrel. This tightening of the nuts allow the tip to have a good electrical connection to the barrels and this is what allows the tip to heat. You actually have an electrical current that passes through the barrels and the tip. It is a very low voltage (around 2) but a very high current. Over time the tip will not heat, this is a sign to either tighten the nuts, or look at the tip to see if it has a break in it. If it has an open, then it is time to change the tip.

From the phones main menu press and hold the J key untill silent activated displays........

Hi, I'm not sure the tip is defective. Check that the tip is screwed in tight. If it is not good and tight the tip will not get a good heat transfer from the solder wand. Hope this helps. If the wand will heat then the tip should.

The tips can be purchased from MCM Electronics here:

http://www.mcmelectronics.com/product/WELLER-8125N-/8125N

Dan

Diagram A

Style: Flat with ribs
Installation Tips: Ribs face toward drum
Diagram B
Style: Flat with ribs
Installation Tips: Ribs face toward drum
Diagram C
Style: Flat with ribs
Installation Tips: Ribs face toward drum
Diagram D
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram E
Style: Flat with ribs
Installation Tips: Flat side of belt against drum
Diagram F
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram G
Style: Flat belt
Installation Tips: Side of belt with words faces away from drum
Diagram H
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram J
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram K
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram L
Style: Flat with ribs
Installation Tips: Ribs against drum
Diagram M
Style: Flat with ribs
Installation Tips: Ribs against

i have an old 8200 and i just bend the ends of the replacement tip, then i just tighten the bolts. that is how the tip was on the when i bought the 8200. cheers