There is an error showing "Error Code 6a80" tells

6A80 - APP position error. Often there is something in purge unit

Cannon IP3680 service error 6A80 Solved Problme

APP position error or Error Code 6A80
Condition: An error occurred in the APP motor.
Problems and Solutions:

• Check for foreign material or paper debris around the purge drive system unit
  - remove foreign material.
• Check for foreign material or paper debris around the ASF unit
  - remove foreign material.
• If other solution fail, replace one off the following part
  - Purge drive system unit
  - Logic board

for more info visit: http://pcmediks.blogspot.com

@font-face { font-family: "Times New Roman"; }@font-face { font-family: "Verdana"; }p.MsoNormal, li.MsoNormal, div.MsoNormal { margin: 0in 0in 0.0001pt; font-size: 14pt; font-family: Verdana; }table.MsoNormalTable { font-size: 10pt; font-family: "Times New Roman"; }div.Section1 { page: Section1; }

Issue: ERROR LCD: Error Code 6A80

Solution #1: Press ON/OFF switch to reset the multifunction device

Reset the device when it is not functioning properly.

If the device is not functioning properly or to clear memory, reset it.

1. On the operator panel, press and hold the button for one second. (The display will go blank.)

Note: It may be necessary to unplug the power cord if pressing the ON/OFF button does not shut off the printer.

2. Wait approximately ten seconds and then press the button again.

3. Wait until the device has completed its cycling process before submitting another job request.

Issue: ERROR LCD: Error Code 6A80

Solution #2: Removing paper jams MX700

See very detailed description at this link:

http://www.usa.canon.com/cusa/support/consumer/printers_multifunction/pixma_mx_series/pixma_mx700#ServiceAndSupport

This should do it

http://fix-your-printer.blogspot.com/2009/06/error-code-6a80-on-canon-printers.html

Please visit the appended link for more information.

Don

http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&tabact=SupportDetailTabAct&fcategoryid=238&modelid=12804

6A60 error is an APP (Application Printer) position error. It means that an error has occurred when the motor was running during the purging operation on start up.Check the sheet feeder and purge unit.Sometimes pieces of paper stuck in purge unit.

Thank you!

That error says there is something jammed in either the purge assembly or the sheet feeder on the back not able to turn. The purge assembly is on the right where the printhead parks for cleaning.

hi,
Go to the link and follow the steps that r given:

http://fix-your-printer.blogspot.com/2009/06/error-code-6a80-on-canon-printers.html