I have full power,but the warning alarm and light are on.

the power failure alarm is there for a reason.

Hi, the first step should be to check the meaning of warning indicators (lights) in technical documentation of server, and if it´s available the alarm log file to analyze and troubleshooting.

Warning light (red)
If the temperature warning light (4) lights up, it
indicates that the temperature within the freezer has
reached a level where the safe food storage is no
longer ensured. When the freezer is first switched on, the warning light will stay on until the temperature has dropped to
a safe level for the storage of frozen food.

Temperature acoustic alarm
This appliance incorporates an alarm which gives off
an audible signal whenever the warning light comes
on. This signal can be temporarily stopped by
depressing the push button for fast-freezing (6).
The fast-freezing push button can be released as
soon as the warning light is off.

Open door acoustic alarm
This appliance also incorporates an alarm which
sounds if the door is left open for more than 60
seconds. The signal will be stopped when the door is
closed again.

Dado

The most common reason for a false reading, where the bin full light comes on but the shredder basket is empty, is simply dirty sensors on the bottom side of the shredder head.

that indicates full waste ink pads/absorbers. to reset the counter try this:
1) With the printer power turned off, while pressing the Resume/Cancel button, press and hold the Power button.
(DO NOT release the buttons. The Power LED lights in green to indicate that a function is selectable.)
2) While holding the Power button, release the Resume/Cancel button. (DO NOT release the Power button.)
3) While holding the Power button, press the Resume/Cancel button 2 times, and then release both the Power and
Resume/Cancel buttons. (Each time the Resume/Cancel button is pressed, the Alarm and Power LEDs light
alternately, Alarm in orange and Power in green, starting with Alarm LED.)
4) When the Power LED lights in green, press the Resume/Cancel button the specified number of time(s)according to the function listed in the table below. (Each time the Resume/Cancel button is pressed, the Alarm and
Power LEDs light alternately, Alarm in orange and Power in green, starting with Alarm LED.)

any way if the absorber/pad is full, it have to be cleaned!

This sometimes is triggered by the MAF(Mass Air Flow Sensor), try cleaning it with the highest percent isoproply alcohal first, do not touch the sensor with anything use a big bag to soak it into, or just replace the sensor.

another case of boy racer alarm problems ,this vehicle is fitted with a factory immobilisor ,if i wanted to steal this car the alarm wouldnt stop me i would just lift vehicle up with a flatbed breakdown truck and no one would even look twice .best deterrent is a krooklock on the steering wheel and keep the key seperate from the ignition key,most vehicles are stolen with a house break in for the key ,criminals are smart and know they cannot get past the immobilisor .also keep a spare krooklock key in the vehicle and do not tell anyone

Dont have the manual in front of me...recollect that there's two types of warnings. The pulsating warning is oil (starts with 30 minutes of oil left) or the fuel filter (or sperator, something like that) may have water in it. Running outboard with cover off, is a little black box that would have a red light lit if that's the case. If oil full & no red light, may be oil injection system...would also check to make sure lines aren't pinched, etc. Mine has been specific to oil the two times its gone off.

The full non-pulsating is engine overheat. Not sure beyond that.

Not much, but hopefully gets you going.