I have a dagobah Habitat and it is going great!! However the tadpole has its arms and legs now and I lost the instructions help!!! is their any online that I can look up??
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I had the same problem with exact same vacuum, was working great and the one day just lost almost all suction in the hose and in very very poor suction on base when vacuuming carpet, also when vacuuming the carpet everything I vacuum shoots out the bottom and hits my feet, never happened b4, checked all hoses and tor apart every thing to see if their war dust in motor, clogging anywere but nothing everthing looked great, NEED HELP CANT AFFORD TO BUY ANOTHER VACUUM OR TO TAKE TO REPAIR MAN TO B CHRGED AN ARM AND LEG, SOMEONE PLEASE HELPPPP!!!!!!!!!!
Tadpoles can eat a suspension of Nettle Powder which is carried by many Health Food stores in the bulk section. Put a pinch into a little bit of water and then add it to the tadpoles water.
Hi, I know this probably won't help whoever posted this because I'm
really late, but it will helpfully help out those still searching
online. 1. Attach one leg brace (E) to the leg (F) using two
M6*40 screws (K), four washers (P) and two nuts (Q). Repeat this step to
attach the other leg (F). See Fig.1 2. Attach the other leg brace (E) to the legs (F) using one M6*40 screw (K), two washers (P) and one nut (Q). Repeat this step to attach the other leg (F). See Fig.2 3.
Attach one rocker connector (G) to the leg (F) using one M6*55 screw
(M), two washers (P), one spacer (O) and one nut (Q). Repeat this step
to attach the other leg (F). See Fig.3 4. Attach the other rocker connector (G) to the leg (F) using one M6*60 screw (N), two washers (P) and one nut (Q). Repeat this step to attach the other leg (F). See Fig.4 5. Attach the left arm (B) to the chair back (C) using two M6*35 screws (J) and two washers (P). Repeat this step to attach the right arm (A). See Fig.5 6.
Attach the chair seat (E) to the arm front side using two M6*20 screws
(I), two washers (P) and two large washers (S). Attach the chair seat
(E) to the arm rear side using two M6*35 screws and two washers (P). See
Fig.6 7. Attach the assembled chair bucket to the lower end of the rocker connector (G) using one M6*50 screw, two washers (P), one spacer (O) and one nut (Q). Repeat this step to assemble the other three connection points. See Fig.7 8. Fully tighten all screws using wrench (T) and Allen Key (U). Cover all hardware with screw caps (H) and nut covers (R) respectively. See Fig.8
You'll receive 25 to 30 non-breeding adult Harvester worker ants.
Important: Before you open the tube of ants, place the
tube in the refrigerator (not the freezer) for about 15
minutes. This makes the ants less active and easier to
place into the habitat.
When you're ready to add the ants, carefully
open the plastic tube and gently shake or tap
them in. Replace the habitat lid securely.
×