I have a 1 in all four corners of my T.V. and a 189-0.19 thing in the center of the screen and can't use my remote to fix the issue

Edge lit sets have a tendacy of having sections of the backlights bad, there are 4 to 8 zones with about a dozen lamps in each zone, if you have dim edges the outside sets have failed. The issue with replacing them is the lamps get very warm before buring out and in most cases, it damages the defuser panel, so it doesn't spread the light correctly. Start by taking the screen (panel) out and defusing screens and see if the thick one is damaged, either cracked or warped, if it is it's time for a new TV, if it looks ok you can get parts from shoppjimmy.

Your question is very vague, but it sounds like the picture on the TV has faded away in the corners and probably looks like a circle in the center of the screen....? If so this has nothing to do with your remote control and everything to do with the TV . I would toss it and invest in a new flat screen. Don't waste money trying to repair TVs - they are now disposable items.

it is calibration, hold your finger on the x until it moves to the next number.

You might have to resync the remote take off the battery cover and push the red button under there to resync it with your wii, you will have to do the same thing with a brand new remote or when taking the remote from one wii console to a friends.

If this isnt working then your remote batteries are bad or you are having a hardware issue with the remote. Unless your trying to play a game cube game this is another issue and has nothing to do with your wii remote working or not.

post back if this dont fix your issue

Unfortunately you will have to replace the convergence board in this unit. it has failed. this particular board regulates the alignment procedure that you are having issues with. replacing this board will fix this issue.

I had the exact same problem already and my LCD is less than 8mo old. One of the techs from AKAI told me that its a known problem and many tv's were coming back "unserviceable". They now have a "supposed" fix for the problem. I only hope it really works and its not just a "carry-over" until the warranty ends. I am beginning to think its a quality issue and the units may just be defective. Thismay be thier way of doing a quick-fix vs. recalling all those tv's. This is what he gave me to as a solution to give the serviceman when he comes to fix the LCD.

AKAI model LCT42Z6TM: If there is no image or a badly distorted image with horizontal static lines, usually with four boxes in all four corners of the screen, there is a possible fix for this. There are four capacitors on the main board that have been identified as the primary cause of this symptom. Replace the capacitors at location numbers C280, C302, C320, C323 - 100UF 35 VOLTS [dxh]

unplug it and plug it back in. this should fix it

Touch screen not working for sony ericsson P990i Mobile phone

When I hit the center some part above gets highlighted and selected and the botton part where the taskmanager and battery icons are present does not respond to my taps ... what could be the problem,,, kindly help me solve the issue.

Praveen

There is not much you can really do to rectify a screen problem, but there are four little black blanks in the corners of the screen,remove and see if any tightening or loosening of the screws alter it. Caution applies as the wireless receiver is built in the screen and can get damaged and that may also be causing the interference.

This doesn't sound like a programming issue. I had a very similar problem about 6 months ago and I fixed problem. I had cold solder joint on the video power board. It was the board in the middle. The power supply was to the right. The video board had a driver with a bunch of legs. About 7 solder joint where cold or loose. I solder the board and my mitsu wide screen was fixed. Hope this helps.
Andy