Cannot find wire from dishwasher to hook it up.

Go to a hardware store and get a Dishwasher Hook-up Kit. It will include a flexible hose along with several adapters. You dishwasher should come with a drain hose. You will also need a 3-wire "pigtail" (an extension cord with no receptacle or socket at the end). Your dishwasher whould have come with installation instructions, but seriously, if you've never done that before (or done similar work before), you should call a professional installer or at least and experienced handy-man.

If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

Hi,
Behind the kick plate you will find a little electrical box... usually on the right front corner under the dishwasher...run a 15 amp. 120v circuit to the box, then just hook the ground to the green screw, the white wire to the white wire and the black to the black...that's all there is too it...

heatman101

Attach the green ground wire to the frame of the device ... there should be a green screw close by the place you hook up the power.

Hi,
The Black wire is the Hot or positive wire and the White wire is the nuetral or negative wire.
The green wire gets hooked to the frame or any metal part of the dishwasher...usually there is a green screw inside the little box where the wires hook up

Heatman101

white to white

green to green or bare

red or black to the red or black from the house wiring.

This is more then likly a melted wirenut. turn breaker off, remove bottom panel and cover for wiring hook up, check wirenuts and wire for any heat damage.

Here is a little video to show exactly what to do. If you have an outlet to plug your dishwasher into just add a power cord to the connecting wires. Otherwise do as it shows in the video and hook the dishwasher up to a power cable coming from the electrical panel.

The green is the ground wire. Attach it to the screw inside the junction box.

If you have a volt/ohm meter you can check for Power on the Blue wire. Or you can open the face of your fuse box and look to make sure the Blue wire is connected to the fuse. If it is, just hook up your Black from dishwasher to the blue from house. White to White ( Neutral). There is no real way to ground the dishwasher if your house wiring is a 2 wire (old) system. You shouldn't have a shock hazard if the wires are in the junction box for the dishwasher.
Bill

Take the screws out in the dishwasher door and open it up. Then move it over wire for wire from the old to the new.