My G6 Vacuum won't start, and I was wondering ifd it had a restart button? It does, I can not find it.

Kirby G3 G4 G5 G6 Vacuum Cleaner Shampoo Shampooer Kit Carpet System... 744results for kirby g6 vacuum cleaner

sounds like the drive belt has been overstretched. replace with a new one and see if that helps.

here are some diagrams that may help you of the G6
http://www.vacpartswarehouse.com/Kirby-Generation-VI-G6-Upright-Vacuum-Cleaner-s/2820.htm

Lift Roomba off the floor and place it in the center of the room and restart the clean cycle.

If Roomba did not resume cleaning, lift Roomba and turn it over.* Inspect the Side Wheels for dirt or obstructions.

Test the Side Wheels by pushing them in and out and making sure they rotate freely. Place Roomba in the center of the room and restart the clean cycle

.

One set button on your Kirby. Remove the head to check for blockage in the fan.

check for blockage or impeller if vacum makes loud noise the impeller is the part that gives it suction

Hi
Either the bag or the main head is not locked on correctly

You can look at the wiring diagram and try to figure out how to use a circuit tester to test the switch but I would just suggest just swapping it for a good one (always good to have one good switch for testing) and see if it solves the problem.

Good Luck
Rocky

Sure can,

You have two choices,
1.) To use your shampoo attachment, you'll need the fluffer shield, To set up the attachment seperate the tray assembly (the part that holds the roller brush) from the nozzle assembly (the part that attaches to the machine). Now seperate the roller brush from the tray (easiest way is to pull the belt). Insert the roller brush into the fluffer shield (it only goes one way). Insert the fluffer shield with the roller brush installed into the nozzle assembly the plastic shield will be faced towards the front of the machine. Turn belt lifter to where the red arrows match and attach to the front of the machine. Turn belt lifter to where the green arrows match and you should be in business.

2.) Your using the floor buffing attachment it the easiest method just put on like the floor nozzle (thing you vacuum with).

The Kirby G6 Vacuum Manual is available for free on this site: http://ubermanuals.com/product/kirby-g6-8499 .