Unable to sent a fax communication error - Epson Stylus Multifunction Inkjet Printer/ Copier/ Scanner

-Busy/No signal.
-The other party did not respond when your machine
dialed/redialed.
-The documents could not be sent because the other party was
engaged with another communication with another party.

Speed all about speed and noise on the line, on some of my accounts I "de-tune" my unit to communicate with the "problem" units and sometimes I will turn the ECM off. -Carl

That's not the way to backup your logs. You copied only the fax images, and not the logs to go with them. This is a common error that is made quite often. Unless you have the original log structure, your data (logs) that link to the actual fax images (fxds, fxrs, etc.) are lost.

Troubleshooting WinFax suggestion:
http://www.getfaxing.com/cgi-bin/ib315/ikonboard.cgi?act=ST;f=17;t=412

cartridge error

She may have a digital phone line, such as DSL...Vonage...etc.

232-A communication failure has occurred between the two machines.
327-*Reattempt the fax reception at a different time when telephone line conditions have improved. Call the telephone provider if line conditions fail to improve.
356-The remote user has pressed the Stop key, causing the session to be aborted.
442-An error occurred during transmission after one or more partial pages had been sent. The transmitting machine was unable to restart the control channel (handshaking) before sending more data. This error typically occurs when the receiving fax disconnects after receiving part of a page but can also occur if the receiving fax is using a fax format that is incompatible with the HP fax machine (usually during color faxing).

Some basic troubleshooting tips are listed below to help determine the cause.
Check the following items :

1
Ensure the phone cord is plugged directly from the wall jack, into the back port of the fax machine marked "Line", "To Wall Jack", or with a wall jack symbol

2
Remove any other device from the line such as splitters, credit card machines, or telephone answering machines and retry.

3
Turn Error Correction Mode (ECM) off ,
For turning off ECM > press set up > press ok >go to advanced fax set up by using the arrow key > press ok > press arrow key go to OFF > press ok .

After these steps > try to send a fax to undermentioned number , once it is sent u will recieve a confirmatory fax in return as well .

self confirmatory no for fax 1 888 473 2963 .

or u can try to send a fax to a different local number as well.

Thanks

keep the window closed ok? that's more along the lines of the phone issues, than the fax machine itself..there are many ways to outwit the phone tree issues, but each number would need to be encoded directly.

solution?

get a dedicated inexpensive fax machine, or use efax.com

when I sent a fax via Satellite communication, I got error 503 for few customer - it seems I need to change ECM at the remote site .. any advice

error 209 - Media Table Download Failure MediaTable Download to PU failed. Reboot.

CU firmware detected an anomaly in behavior in PU (including a violation of communication protocol between CU and PU).

are you suing unusual sized paper?