I would like to print out an owner's manual for the Europower PMP 3000 mixer. Please tell me if this is possible. Thanks - Emily Castle

Question Edited to add make and (what it is). Please always include as it helps us to help you better.

Direct to the factory.

https://www.behringer.com/service.html

..

You will need to give more information for a proper reply, which unit you have and what you want to do with it, what into it and what out etc. In principle you can treat it as a pre/post mixer using it's ins from either the aux or group outs of the mixer or conceivably the inserts depending on what you want to do. You could use it in front of the mixer or as an adjunct. Please tell me what you are trying to do.

You can get the entire service manual for this unit here:
BEHRINGER PMP6000 SCH Service Manual free download schematics eeprom...

You can download Service Manual of Behringer PMP3000 free of cost on below link:
https://www.electronica-pt.com/esquema/audio/behringer-audio/behringer-pmp3000-16040/ Behringer PMP3000

What is up is one of the two power amps is blown... I know this problem... It is USUALLY the rearmost channel which goes to the left Speakon faacing the back. Weak insulation between layers of the multilayer circuit board arcs and fries three transistors and a diode and sometimes a few more components. It takes a lot of skill to restore the module and is beyond most repair shops. A whole new module costs about $155 from Full Compass. The amp is an HCA2400 module, but you MAY need the Behringer part number to order it from Full Compass. Also please read my tip on Fixya for PMP mixers regarding the hazard when using 1/4 inch plugs from the Speakon connectors... the Channel A sleeve is the "hot", not the tip and if you ground the sleeve, goodbye channel A...

This is likely a power supply failure, possibly brought on by a failure of one of the amp channels.

This is probably close to your supply:

http://elektrotanya.com/behringer_sps600_power-supply_sch.pdf/download.html

Scroll down to "get manual" and click on that to download schematic. Ignore other download links.

Plug a balanced TRS (tip ring sleeve) cable into either main or monitor 1/4 inch jacks and then into the amp. ALWAYS use balanced lines AND power the mixer AND the amps from the SAME receptacle to avoid damage from ground loop bounce,

First thing is to read my tip regarding a speaker polarity hazard of the PMP mixers.

Second thing is to VERIFY speaker cables are properly connected.

If you are using in stereo mode set the slider switch to MAIN L/Main R.

describing all possible configurations is not possible on here, but read your manual with this. If you don't have a manual, download one for free.

Unit has wide range power supply will operate on 100 volts to 240 volts without any change other than possible plug adapter to mate with each countries receptacle standard.

Hi,

You can download the manual by clicking this link

You'll require Adobe PDF Reader installed on your PC to view this manual. If it is not already installed on your PC, download it free from:

http://get.adobe.com/reader/

Hope this solves your problem. Thanks for using FixYa