I have a La Crosse wall clock, model WT-3102. It stopped running so I replaced the battery. The clock immediately moved to 4:00 and stopped. I left it overnight but it didn't move. I removed the battery and then put it back. The time changed to 8:00 and stopped. I did it again and the time moved to 12:00 and stopped. I tried a third time and it moved to 4:00 again and stopped. What should I do?

Question edited for clarity and toss in some CAPS.
question moved from Audio Players category.

Set Up starts here in the manual

https://www.manualslib.com/manual/1591844/Lacrosse-Bbb86088.html?page=4#manual

..

check out this video
WT 8005U Atomic Digital Wall Clock

Once the battery is installed the clock will begin searching for a signal. For the initial setting it is recommended to stand the clock in an upright position near a window. Within five minutes the clock will either receive the WWVB signal and set itself to the exact time, or it will determine that the signal is not receivable at its current location and time of day. If a signal is not receivable it will fast-forward the hands to the 4, 8, or 12 o'clock position and search for WWVB each even numbered hour until a signal is received. If the time is manually set the clock will continue to periodically search for a signal and automatically reset the hands when the signal is received.
What I would do, take the clock outside, it might not be getting a signal inside your house.
http://www.manualslib.com/manual/91008/La-Crosse-Technology-Wt-3181pl.html

http://www.lacrossetechnology.com/products/resources/misc/8005-manual.pdf

download the manual from here: http://www.manualslib.com/manual/533191/La-Crosse-Technology-Wt-8005u.html

If you have not talked to La Cross and if you continue to have the problem, most likely it may be a signal problem. I had a similar
problem with an earlier model and found that it only worked on
the west facing wall as the signal is coming from WWVB which is the NISTtime signal radio station near Fort Collins, Colorado. Get a fresh battery, reset the clock, put it in a west facing window and leave it overnight. If it doesn't work, contact La Cross as above post.

Hi!

Directions:
http://www.klockit.com/PDFs/lacrossemanuals/AnalogWallClocks.pdf

For warranty work, technical support, or information contact:

La Crosse Technology, Ltd

2809 Losey Blvd. S.

La Crosse, WI 54601

Phone: 608.782.1610

Fax: 608.796.1020

e-mail:

[email protected] (warranty work)

[email protected] (information on other products)

web: www.lacrossetechnology.com

Try this link and follow the instructions.

http://www.lacrossetechnology.com/3143a/manual.pdf

don't push any buttons at all untill the clock has at least 15 minutes to communicate with the transmitter.