Need 4 dig code for onkyo remote to a sony tv

The Onkyo RC-649M remote was included with the Onkyo HT-S790 (with the HT-R540 receiver), among other sound systems. The directions for using this remote are thus in the HT-S790 manual. Onkyo has this manual here: https://www.intl.onkyo.com/downloads/manuals/pdf/ht-s790_manual_e.pdf . See pages 13-17 for information on using the remote. Look at page 69 and the subsequent pages for the remote control programming directions and code list. To program the remote for a specific device, press and hold the Mode button (TV, DVD, etc) that you want to program. While holding this mode button, press and hold the Display button (the lowest button on the left side of the remote) for 3 seconds. Then enter the 4 digit code that applies for your device/manufacturer. (If there are multiple codes, you will need to test the remote and try again until you find a code that works.)

I hope this helps.

Cindy Wells

Sony
1100, 0000, 1505,
0353, 0810, 1167,
1300, 1651

Otherwise check your remote model at:
http://www.us.onkyo.com/download/own_manuals.cfm?cat=Remote%20Control

Best of Luck!

Rick

this is the link for onkyo receivers you are missing 1 # on your model #
http://www.onkyousa.com/download/own_manuals.cfm?cat=Receiver

Sony TV codes for the Onkyo TX-SR605 are : 0000, 0650, 1100, 1167, 1300, 1505, & 1651.

Instructions for the Onkyo RC682M and more remote codes are available here. The Onkyo TX-SR605 manual is available here.

I hope that helps.

you cannot control a ps3 with that remote because the playstation 3 only works with bluetooth. I'm sorry to have to tell you. you can purchase a remote that works with your system at any that sells your system.

hope this helped
please rate well.

If you need further help, reach me via phone at https://www.6ya.com/expert/mark_445a24324be9eb03

you could try getting in touch with the manufacturers of the receiver,or if you have a code in its manual for a sony dvd,you could try that as that all blueray is,it might not matter about model of dvd.

Your onkyo receiver and remote controller only decodes 4 digit codes so what you have to do is to call the manufacturer of the remote controller it self and ask for the hexa decimal codes for their remote. They should provide it to you coz they're the ones responsible on doing that.

Player can be made to work without remote. But it is a pain.
You need to press pause then play in the right combination.and you can get both DVDs and Blu Ray disks to work. I bought a store floor model that did not have a remote. I went through the same problem when I would lose the remote for the HD-DVD player. My four year old daughter knows this trick pause pause play for DVDs and pause play pause play for blu

PRESS SETUP GO TO MISCELLANEOUS PRESS ENTER THEN DOWN TO OSD SETUP PRESS ENTER AGAIN AND DOWN TO MONITOR AND CHANGE TO 16.9.

HOPE THIS HELPS.

CABLE GUY.