Hello my jabra wont light up when it is fullcharge? can you help me?

The unit needs a full charge. Be certain the BT firmware and software with drivers are current. If necessary, contact the manufacturer support technician for additional assistance.

To get the Jabra SP5050 into pairing mode: Start with the unit turned off Press and hold the answer/end button Hold until the light starts blinking constantly, without pauses Release the button - this is pairing mode Your phone should be able to "find" it when it's in this mode.

not a radio communications issue

Hi,
1. Turn headset off. Press and hold until solid light comes on.
2. Activate Bluetooth on your phone.
3. Search for Bluetooth devices and select Jabra BT500.
4. Press ‘OK’ on the phone ,If the phone asks for a PIN then confirm with PIN code 0000 (4 zeros)


Thank You

The headset has to be in learning mode first for any phone to find it, press and hold the power on button for 8 seconds until the power light comes on and stays on then search for it with your phone, pairing code can be 0000

hello. any one of these dealers should be able to assist you. http://www.jabra.com/NA-US/WhereToBuy/pages/Default.aspx

please mark my answer as very helpful. thanks. Joe

You might want to delete the Jabra headset from the Rumor first, and make sure the phone is powered off. Then put the Jabra into pairing mode (usually done by powering on the Jabra and pressing and holding until the indicator light flashes) and set the Rumor 2 to detect new devices. Once it detects the Jabra, connect and input 0000 (four zeros) and it should connect.

Hello,

In your Jabra bluetooth headset, press and hold the button in the headset until you see BLUE flashing light. Once the light is flashing in the Jabra, go to your Motorola phone and search for any Bluetooth device in range. when the Jabra shows up, select the Jabra and put in the pin code for the headset "its either 0000 or 1234)

Cheers!

How do I have to set up my Jabra head set?