New radio, TX/RX freq. off 7khz and clarifier non functionable

tx is the word for transmit and rx is for receive
if you press the talk button, the unit goes into transmit mode and is received in the receiver of the other unit/s
now that your statement has been clarified what was the question?

To programme a repeater. VFO mode & curson on top line of display. Enter freq eg 147.250. Go menu button change settings like offset, tone. In menu delete channel required eg 000. In menu below that, choose mem channel now 000 & it saves receive freq.

Exit. press *SCN button so R appears on display. Save as 000 again but this time it stores TX freq. In other words, you save RX first, then exit.Add * so R appears in display second time round and save again TX freq. Go to channel mode and see it is in 000.

I might do a video to help people. Its the same process with UV5r and other Baofeng. Simplex you just save in one operation because TX is RX.

This could be a couple of different things,the easiest is your freq.somehow got off the worst case is the PLL went bad,either way your going to have to take it to a shop.Sorry

look at a schematic of a 29ltd to do that.. the 25 does'nt have it in there easily.. the 29 can be fixed to change tx/rx freq. with the delta tune

Use a known good external freq counter, and do the tx alignment. that will put your meter back on showing the right freq when you are..

the roger beep circuit is next to mic connector and tx/rx cirucuit. the freq counterDISPLAY is on seperate circuit.

.002 Mhz is really not that much off, try having them tune to your signal When I talked SSB I would have everybody tune to my signal.

Unfortunately, most people look to unlock the clarifier in radio's it is locked in.

From what I understand it is possible to lock it in that radio, however I do not know it because I usually unlock it in my radio's.

I also did a search, and asked a few people I know who are also very good with radio's and they do not know either. The only thing I found was this, and you have to pay this shop to do it.

http://cobraworxshopz.com/12.html

Sorry about taking so long to respond. These radios have worked properly in the past. They have increasingly become worse to the point they will not Tx. I have tried to com-cate with a good radio but unsucc. I'm thinking the Tx freq has been altered? Can one freq (Tx) be altered and not the other (Rx) or will both become altered?

the two radios are on different CTCSS Tones