Volume controls don't work

check your remote manual if it don`t work you might have to get another uv remote that work!!!

Good day Mr.Daniel Navarro..

The picture below is the sample 42" plasma TV (internal parts)..

If your TV won't adjust volume or change channel by pressing button on the front panel..The problem could be the digital control board,it is the one that have a rectangular red on the image shown..

But before you replace the board make it sure that the control button assembly is properly connected on the said digital control board ( no loose connection or loose solder)..

Also try this remedy:
If you have remote control you can use it for the mean time to adjust the volume and channel so that you don't need to replace the digital control board..

Hope it helps..

Thanks for using fixya and purchased my service..Please don't forget to rate my answer..

Hello;

I found the following reference to resetting anything related to the ZN110 remote:

"This remote control works well for all the basic functions on the television: changing channels, adjusting volume, and turning the set on and off. There is not a way to program the TV with the remote control, so if you need to reset the channels after a power outage, for example, you have to do it manually on the TV set itself."

Or it could just be batteries?

Pamf6, I am unsure what model of remote you have so I am unable to provide you a code. The steps below will help in programming the remote to the TV, and I included a link on the bottom that has the codes on it.

Program to TV:
Remotes: Basic (Television Only)

1. Turn the Television On
2. Press and hold the gray TV button on top of the remote until all lights turn on.
   
3. Let go and TV will be blinking, enter the three-digit code using the buttons on the number pad.
4. Press #
5. Test functionality with the TV
6. Return to Step 2 if the remote is not able to turn the TV On/Off, change the volume and mute the television. If it works press SAT.
   

Link for codes:

http://tech.dishnetwork.com/departmental_content/techportal/content/tech/remotes/TechRemo5.3Code.shtml

Tommy Faust
DISH Network

the remote control buttons were stuck

I had this same issue, and solved it by putting the TV in "Theater Mode', which can be acheived by hitting the "Theater" button on the remote.

Replace all the tac switches.

Buy a new remote.

Well there is still a problem with the TV. I found that by unplugging the power cable that the digital channels worked. But, when I turned the TV on today the problem had returned, I had to take out the power cable again!

Hello

If it is just not functioning for volume but do perform other functions then do open in there would be screws or can just be lock's clean the board and pad with cotton dipped into acetone if you don’t have acetone just use the dry cotton if it still doesn’t work change the remote

Good Luck