Inash_LG Ref Model is GR-642BEPF,i have been replaced the compressor but getting not start,but the wrong.i think its PCB burnt

My best idea...

Try the compressor start CAPACITOR...

which is usually pretty INEXPENSIVE...

ELSE
You are likely looking at a CONTROL BOARD or a REPLACEMENT compressor which is expensive and really expensive (respectively).

Let's hope not

I tried to look up your GR-B206GTQA number but got
no USA (domestic) responses...

Sorry!

Some of our part houses like
appliancepartspros.com have some VERY EXCELLENT
video guides.. and customer FORUMS.


Try searching on your LOCAL internet for so RELEVANT
spares suppliers and possible ADVICE.

Happy hunting and good luck

Question too involved. Either you can or must pay someone who can.

Write your answer...hi my lg expresscool evaporator fan motor not running, if I press a test button on PC board it runs but the display locks,what could be the problems modelGr- B712ylp

regards
Art

I also have LG GR 282MV, and now its getting heat up from both side walls as I had stopped using it for 1 year now today I started to use but it was heating up. What is the fault.
Regard,
Amber

Hi,

Many times a freezer and/or refrigeratordo not work right because of a dirty condenser coil...there are also many otherthings that can go wrong. If you are hearing a clicking or buzzing thencheck out the last two tips.

If your refrigerator is running but warm, then...

Check out these tips that I wrote about that... it is a great place to starttrouble shooting your unit...and something that you can do rather then callinga repair person to do a simple thing for you...

Refrigerator Condenser Coil Cleaning Refrigerator Repair

Refrigerator Troubleshooting Refrigerator Compressor

Refrigerator Compressor Start Capacitor and Start Relay
Refrigerator or Freezer not Cooling or Getting Cold

heatman101

Hi,

Many times a freezer and/or refrigerator do not work right because of a dirty condenser coil...there are also many other things that can go wrong.

If you are hearing a clicking or buzzing then check out the last two tips.

If your refrigerator is running but warm, then...

Check out these tips that I wrote about that... it is a great place to start trouble shooting your unit...and something that you can do rather then calling a repair person to do a simple thing for you...

Refrigerator Condenser Coil Cleaning Refrigerator Repair

Refrigerator Troubleshooting Refrigerator Compressor

Refrigerator Compressor Start Capacitor and Start Relay

Refrigerator or Freezer not Cooling or Getting Cold

heatman101

try to check your compressor resistance using ommeter or connect one test prod to terminal of compressor and one test prod to the body of your ref, if the pointer move or you read resistance it means your compressor burn out need replacement. or try to check your over load protector may be it damage.try to replace. the terminal of compressor is 1.2.3.connect the one test prod to 1&2 then read resistance then 2&3 then 1&3 these 3 terminal have different resistance these means your comp. is good.if good try to look fuses if damage replace it. observe unit. check your voltage supply may be it is higher than the rated voltage of your ref cause of burn out of your main board. or inspect the main board possible water leak the got wet the pcb boaerd

most only need the model and serial number of the unit.ref. freezer

6 - DC Peak Error

• Supplied power is not normal

• Comp Connector (CN-U,V,W) is disconnected or inserted to wrong

position

• Compressor is damaged (coil short) ? replace compressor

• Too much Refrigerant
• Defect in outdoor pcb assembly ? replace pcb assembly


Try turning power off to external unit, usually resets diagnostics and runs OK. If not PCB external unit likely culprit, replace!