Remote speaker for Durabrand DWT2405 24" TV

This information comes from the online reference book: Using the Sound Menu

Use the remote to open the TV menu. Select the Sound menu, and the "speakers" decision. From the two choices, "TV Speakers" tells the tv to use its built-in speakers. "Audio System" tells the TV to use an external audio system, and disables the internal speakers. Select "Audio System," and check to see if it works. If it still hasn't recognized that there is an external audio system plugged in, you may need to clean the stereo mini jack (3mm audio jack) with a small wooden toothpick or similar small diameter non-conducting device.

The volume controller may have been damaged from a power surge or internal disturbance; not related to the a remote control. Your TV has a set of External Out connections, usually RCA jacks colored RED White and/or Black. Red and White jacks are relative to Right and Left Speakers when an attached cord with RCA male connectors are used and connected to an Amp or some type of receiver. You should be able to use the TV OUT Audio to a small Amplifier and connect to a set of inexpensive speakers or any external speaker set. This method bypasses the TV's Internal speaker system as an alternative measure.

Instructions things you'll need:

• Composite video cable
• TV

• 1 Place the front left and right speakers on each side of the TV with the speaker labeled "Center" either above or below the TV screen. Set the rear speakers behind the seating area at head level and place the subwoofer on the floor a few inches away from the wall, which can absorb bass sounds if the sub is pressed against it.
  
• 2 Connect the plug on the end of each speaker to the jack labeled for that speaker on the back of the Durabrand receiver. The cables are permanently attached to the speakers, so each may need to be moved closer to the receiver. For example, the left front speaker connects to the jack on the receiver labeled "LF."
  
• 3 Plug the video cable from the Video OUT jack on the back of the receiver to a Video Input jack on the back of the TV.
  
• 4 Plug in the Durabrand receiver and TV to the electricity and switch on both components.
  
• 5 Press the "Input" button on the TV remote several times until the Durabrand signal displays on the screen.
  

call c/s at 1-800-315-5885 tell them you lost your remote and they will help you.

I do not think that this TV does not have a separate circuitry with its volume control for the earphone. If your earphone is mono, are you using a plug that is mono to connect the speaker?
Try using AWG 20 if you could to see if that helps.
Good Luck.

If you telephone 1-4-all they will sort it for you, they did for me!

The easiest thing to do would be to go to an electronics store, look on the back of the remote control package and look for Durabrand.
It should come with a booklet with the setup codes.

Thats all I got for now.

Hope that helped, good lukc, please rate.

CALL 1-877-337-3639 AND THEY W/TELL YOU TO BAD :-( THAN THEY WILL TELL YOU TO ORDER A REMOTE FROM 1-800-313-8495 OR 1-800-668-1067

try here, http://www.remotes.com/remotes/servlet/rs?a=Search&m=HT%20395&ro=false&qi=161&om=HT%20395&uid=11871289084210

direcTV doesnt have a remote code for durabrand if you want you can call the manufacturer and they can give you the 5 digit code...