Where do you place batteries in a wireless mini mouse

Just had the same problem, the battery compartment is in the top, back part of the mouse, it was a pain to get it open, but once I did everything seemed to work just fine

i have the mini m. for awile want to install in another notebook dont remenber how> helpppp

I think you are facing pairing problem, solution is here, First of all please understand ‘what is pairing’ Pairing is theprocess of coordinating your mouse's transmitter with your mouse's receiver. Itrequires both parts to operate on the same frequencies, usually by using thesame identification code. Pairing takes place to try to eliminate interference.Some devices automatically pair both devices at start up; others need to bemanually paired. Step 1. Plug in RF DONGLE into USB port, Step 2. Put the batteriesin mouse (in right direction, see batteries. Direction symbols in the battery compartment +/- signs) andplace the batteries. Cover, Now you can see thered light glowing on the bottom of the mouse, now your mouse is ready topairing There is two buttons for pairing the mouse BUTTON 1 – this on the RF DONGLE, top/up side BUTTON 2 - this is at the bottom of the wireless mouse, NOTE- after pressing button-1, one time, your RF DONGLE willbe ON SERCH MODE for 7 seconds, Step 3, now press BUTTON 1, one time, and move the mouse, ifmouse curser is not moving then press BUTTON 2 one time – now defiantly yourmouse will work, If you need any other technical support for GMAX, products please contact satish kumar (countryhead gmax technologies)

I had all the same problems listed in fixit and found that all it took was placing all NEW batteries in the mouse.
Press the blue light button on the USB and the little black reset button on the bottom of the mouse at the same time. Worked good from there on.

Check the batteries and the receiver,

You can remove the batteries for 2 mins. and put it back in, also you can try to restart the wireless receiver.

I would suggest trying new batteries as well as making sure the receiver is about 8in to 12in from the mouse and at least 6in from the monitor. If you are still not able to connect, uninstall any drivers you have install for this mouse, reboot your pc and reinstall the software 1st, then connect the hardware and reboot your pc.

Good Luck
C2Solutions

Grip the sides of the mouse with both hands and slide the battery cover
back with both thumbs. Then, replace the old batteries with two AAA batteries. Replace the battery cover. Hope that helps.

The mouse requires 2 AAA batteries.

The piece of plastic on both sides of the embedded dongle, where your palm would rest on the mouse, is the compartment for the batteries. You need to slide the piece of plastic away from the direction of the mouse buttons. You will then be able to put the batteries inside and slip the piece of plastic back on.

There should be a battery compartment on the bottom of your mouse. It might have a small screw holding it in place. Open & remove old battery, replace with fresh battery. Hope this helps & please remember to rate my answer. Thanks.

check the battery and see if its plugged in properly. you may consider setting up the connection between the wireless mouse and the receiver.