I tried to "clean" the oven and only got a F9

Google it/utube/customer service

F9 code is a door latch error code. Either the latch motor or latch didn't get reset. Check the wiring to the latch motor and make sure everything is connected. Also try flipping the breaker and leaving it off for five or ten minutes, see if it might reset itself. If that doesn't work, you can have a latch motor gone bad, a harness issue, or possibly an electronic board that has shorted during the cleaning or operation programs.

F9 Door Latch Error Check latch and latch circuit
F9 Door Latch Error Check latch
F9 Door Lock Warning Check door lock circuit or Replace Clock
F9 Program with door circuit Check wiring
4 different brands of stove indicate an issue with the door lock circuit. Hunt down the the tech manual for your machine on my youtube channel video

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Hi

Thanks for using FixYa. F9 error in your oven/range indicates an issue with the door locks assembly and/or the door latch. To start with check the door lock circuit, you can also try to jump start it to see if it's working. If it's not working then the Electronic Range control has gone bad and should be replaced, if it is working then the door lock circuit should be replaced. Please do rate the solution if the issue is resolved or post a comment for further assistance.

Thanks
Rylee

Hello,F9 error means there is a problem with the lock switch.Check the wiring to the door lock switch (the wire harness may be connected wrongly).Check for stuck lock switch.
Thanks

Hi,
Before you go working too hard to get you oven to go into the self clean (self destruct) mode....check out this tip...


http://www.fixya.com/support/r3969401-self_cleaning_oven_problem

heatman101

" Wish I had read this first. I never would have used the self cleaning option. Thanks for the info!!

My oven was locked and would not open. No lock light was on but the oven was clearly locked. F9 error when I hit certain buttons.

Try this. I unplugged the oven for about 5 minutes. Plugged back in. A LOCK light came on. Held down "Oven Cancel" for a few seconds. Door opened and lock light went off. No more F9 error when I hit those buttons.

The F9 code indicates there is a problem with the door lock.

Try disconnecting the power to the range for 10 seconds and reconnecting. Open the oven door and hold the door switch plunger in while you try these things. Put the control into clean for 5 minutes then cancel clean. You must hold the door switch plunger in for the 5 minutes.

Try canceling the clean cycle without putting the control into clean.



Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

hi there,

can you tell me the model # on your stove please?

I hit the same F9 problem when trying to self-clean, except that the door was locked OPEN.

After much trial and error, I found the following fix: 1. Switch circuit breaker off. 2. Switch circuit breaker on. 3. Press Bake button. 4 Press the small/inside button which indicates that the oven door is closed.

The lock mechanism opened and the oven now works fine.