Copystar CS-1810 Have a C620 on display. How I can reset Copystar CS-1810?

check the charging corona unit.it might be dirty of not aligned properly.clean it with alcohol

Go to Kyocera in your country.Most manuals are available on line free.

that means your laser unit is not spinning up to speed. sometimes, you can fix by pulling laser unit and removing the polygon lens/mirror, then putting a small drop of lube on shaft and re-assembling. other times, you have to replace laser unit. thats quite expensive.

hth,
razors

E70 Before switching on, originals were found on the
document feeder

Hello sir; It's a fuser problem, but you need to reset, the procedure as follow; Press and holding down following keys in order, "stop/reset", "start", and "left copy density", then press "stop/reset" key again, then enter U63 press "start", window will display "CLE", press start again to clear.

Sorry Mike,

No spare parts are available.

Jam code 70 means: No origional feed. Paper is detected on the doc feedr tray, but when the start button is pushed - the origional don't feed through.

Hello sir; "AP" isn't a problem, just let it run for a little while, it will disappear.

I'm sorry, Copystar is not a brand I am familiar with.

Be blessed.

manual download link
http://usa.copystar.com/CopyStarPub/jsp/Kyocera/resource_details.jsp?rid=2076



If it only has lines on copys then
Clean scanner glass (small slit of glass before copy glass)

If it happens on prints and copys then it will more likely be drum.