Msg: 2000-0326 Msg Description: LCD Inverter Error, Unable to turn lamp on

Okay this is common with that old laptop the problem is usually the lcd inverter i attach a tutorial video for you to see and understand what it is.

this part produces the high voltage required to light up the screen and burn out it is under the actual screen below the plastic bezel which is held to gether by screws under little plastic covers locate at top left right and lower left right of the screen Dell Latitude E6400 LCD Inverter Replacement How To Tutorial

Error Code 0326 means LCD inverter error, unable to turn lamp ON/OFF.

• Update to the latest BIOS.
• Turn off your computer and reconnect your LCD cable.
• Repeat the diagnostics by turning your laptop on and tapping F12 and selecting diagnostics
• if you still get that error then it could be these parts LCD cable+LCD needs replaced

Yep, basically what it means is the ic on the board is shot. Order a new board. Or a complete lcd as it comes with the driver , The choice is yours and its up to you..!!

This is a hardware issue. Unless you know much about soddering boards do not attempt to fix this yourself.

TV detected lamp error, problem could be either INVERTER UNIT or one of the lamps. Defective part has to be replaced, lamp error counter reset.

hi,
the interal graphics adaptor is making trouble, to find aóut if it just with your screen, hook up another external monitor and boot up.
Still the problem?
then you wil have to (let) the graphics card (be) replace(d), definitely.

Good luck

Does the external monitor display a normal image?
If the images is OK then the video card is OK.
The inverter supplies high voltage to the CCFL lamp which provides the backlighing and does not jumble the colors on the screen. If you get a pinkish hue or a flashing screen then this would indicate
the CCFL lamp is faulty.
From the description of the fault, it indicates that the fault could be a faulty video cable or video connector. Try reseating the video cable/connector on the motherboard.

Check out http://www.ccfldirect.com. they have a wide variety of inverters and backlight tubes for LCD panels and laptops. I'd change out the tubes at the same time you replace the inverter. The cost is minimal, and will increase the likelihood that you'll be successful

Go on ebay and buy a new inverter for less than $10. Go on youtube to see how to replace the dell inspiron 1526 lcd inverter or the dell inspiron 1526 lcd screen. I put the lcd screen on because sometimes the problem might be your screen. If things don't work after installing the new inverter board, then buy a new lcd screen off ebay. The inverter board and screen are easy to install. Just go on youtube.com to find a video that walks you through it. The inverter sits at the bottom of the lcd screen. Some are screwed on, some are welded onto the screen, some are held by a small piece of tape. Even if you have to pry the old one off, just put the new on on held by a small piece of tape.
10results for Dell Inspiron 1526 inverter board

The error code 2000-032 (LCD Inverter error, unable to turn lamp ON/OFF) sounds like your LCD screen has a problem and needs to be replaced. The inverter circuit is located on a small circuit board on the LCD display panel. You can try reseating the LCD connector and see if this helps. Here’s a link to the service manual: http://supportapj.dell.com/support/edocs/systems/ins6400/en/sm/display.htm#wp1022270


Your responses are intended to improve the level of service provided. Please show your appreciation by rating your experience.
Thank You.